HEDS-56XX AVAGO [AVAGO TECHNOLOGIES LIMITED], HEDS-56XX Datasheet - Page 9

• Manufacturer Part Number: HEDS-56XX
• Description: Quick Assembly Two and Three Channel Optical Encoders
• Manufacturer: AVAGO [AVAGO TECHNOLOGIES LIMITED]

Encoder Mounting and Assembly
1a. For HEDS-5500 and 5600: Mount encoder base plate
1b. For HEDS-5540, 5640 and HEDM-5500, 5600, 5540 :
1c. It is recommended that adhesive* is applied to the
2.
a. Push the hex wrench into the body of the encoder to
b. While continuing to apply a downward force, rotate
c. Remove the hex wrench by pulling it straight out of
4.
The encoder is ready for use!
9
Slip alignment tool onto motor shaft. With alignment
tool in place, mount encoder baseplate onto motor
as shown above. Tighten screws. Remove alignment
tool.
screw-baseplate interface to prevent screw loosening
due to effect of high temperature on plastic
onto motor. Tighten screws. Go on to step 2.
Snap encoder body onto base plate locking all 4
snaps.
ensure that it is properly seated into the code wheel
hub set screws. Then apply a downward force on the
end of the hex wrench. This sets the code wheel gap
by levering the code wheel hub to its upper position.
the hex wrench in the clockwise direction until the
hub set screw is tight against the motor shaft (The
recommended torque to tighten the setscrew is 15-
18 ozf.inch). The hub set screw attaches the code
wheel to the motor’s shaft.
the encoder body.
Use the center screwdriver slot, or either of the two
side slots, to rotate the encoder cap dot clockwise
from the one dot position to the two dot position. Do
not rotate the encoder cap counterclockwise beyond
the one dot position.