XE0092LCC ETC1 [List of Unclassifed Manufacturers], XE0092LCC Datasheet - Page 13

• Manufacturer Part Number: XE0092LCC
• Description: Surface-Mount DAA Modules for Audio or Data Transfer
• Manufacturer: ETC1 [List of Unclassifed Manufacturers]

XE24S Configuration Registers
S0 Answer Wireless Link Request: S0
S2 Wireless Disconnect Character - S2 sets
S7 Link Set-up Timer - S7 sets the length of
S10 Link Recovery Timer - S10 determines the
S12 Disconnect Guard Timer - S12 sets the
XECOM
determines if the XE24S500 automatically
responds to a wireless link request.
S0=0 No response to link requests
S0=1 Automatically respond to link request
S0=128
the ASCII character used in the disconnect
sequence. The default character is tilde “~”.
Range: 0-255
Default:126
time in seconds that the transceiver attempts
to create a link with the destination node.
Range: 0-60
Default: 10
how long in seconds that the transceiver tries
to recover a broken link.
Range: 0-60
Default: 10
guard timer before and after the disconnect
sequence in milliseconds. If any characters
are received within the window defined by
S12, the disconnect request will be ignored..
Range: 0-255
Default:20
Units: Milliseconds
up. The register value must be stored in
nonvolatile memory with the AT&W
command.
Enter Broadcast mode on power-
(13)
S14 Bit-mapped Register - S14 stores the
S23 Serial Interface Data Rate -
S39 Bit-mapped Register - S39 stores the
S104 Group ID Number - S104 sets the Group
S105
values of the ATE, ATQ and ATV commands.
Range 1-10
Default:4
value of the AT&K command.
ID number. Multiple groups may be active in
the same area. Only units with the same
Group ID number can communicate.
Range: 0-255
Default:0
transceiver’s node address. Each unit in a
network is required to have a unique node
address.
Range: 1-254
1 = Set serial data rate to 1200 BPS
2 = Set serial data rate to 2400 BPS
3 = Set serial data rate to 4800 BPS
4 = Set serial data rate to 9600 BPS*
5 = Set serial data rate to 14400 BPS
6 = Set serial data rate to 19200 BPS
7 = Set serial data rate to 28800 BPS
8 = Set serial data rate to 38400 BPS
9 = Set serial data rate to 57600 BPS
10 = Set serial data rate to 115200 BPS
Node Address - S105 sets the
XE24S500