MSM6665 OKI electronic componets, MSM6665 Datasheet - Page 14

• Manufacturer Part Number: MSM6665
• Description: DOT MATRIX LCD CONTROLLER WITH 17-DOT COMMON DRIVER AND 80-DOT SEGMENT DRIVER
• Manufacturer: OKI electronic componets

¡ Semiconductor
• CHB (Character Blink on/off)
• CSC (Cursor Control on/off)
• CSB (Cursor Blink on/off)
• CCB (Character & Cursor Blink on/off)
• BPC (Blink Pattern Control)
• Increment (+1) in address pointer
[0,X,X,X,0,0,1/0,X]
Command used to control blinking of characters and arbitrator (5-dot unit).
This command is executed to the address indicated by the address pointer. Blinking is
on by setting D1="1", and off by setting D1="0".
For blinking of characters, all lighting-on or all lighting-off, and characters-displaying
are repeated.
Choosing between all lighting-on and all lighting-off is controlled by BPC command.
For arbitrator, only lighting bits repeat lighting-off or lighting-off. The blink control or
arbitrator is valid only when ABBC1/5="0" and in the 5-dot unit mode.
Refer to "BPC".
[0,X,X,X,0,1,1/0,X]
Command used to control lighting-on and lighting-off of cursor.
This command is executed to the address indicated by the address pointer.The cursor
is lighting on by setting D1="1", and lighting off by setting D1="0".
[0,X,X,X,0,1,1/0,X]
Command used to control blinking of cursor.
This command is executed to the address indicated by the address pointer. Blinking is
on by setting D1="1", and off by setting D1="0".
The blinking in the address, where cursor-lighting-on is not specified, does not occur,
though the command of blinking is acceptable. Blinking starts by specifying cursor-
lighting-on.
[0,X,X,X,1,1,1/0,X]
Command used to execute both CHB command and CSB command.
[1,0,0,X,0,0,1,1/0]
Command used to control blink patterns of characters.
When D0="1" is set, all lighting-off (35 dots) and characters-displaying are repeated.
When D0="0" is set, all lighting-on (35 dots) and characters-displaying are repeated.
When D0="1" is set, if characters are blank, their blinkings do not occur in appearance.
When D0="0" is set, if characters are in all lighting-on, their blinkings do not occur in
appearance.
D0 is set to "0" affer inputting Reset.
When display data or arbitrator data (1-dot unit) is entered or when the following
commands are executed, the address pointer is incremented by 1.
AINC, CHB, CSC, CSB and CCB.
[D0 = "1"]
[D0 = "0"]
MSM6665-xx
14/30