MSM6665C-XX OKI [OKI electronic componets], MSM6665C-XX Datasheet - Page 8

• Manufacturer Part Number: MSM6665C-XX
• Description: DOT MATRIX LCD CONTROLLER WITH 17-DOT COMMON DRIVER AND 80-DOT SEGMENT DRIVER
• Manufacturer: OKI [OKI electronic componets]

¡ Semiconductor
FUNCTIONAL DESCRIPTION
Pin Functional Description
• SI (Serial Input)
• C/D (Command/Data)
• SHT (Shift Clock)
• SO (Serial Out)
• CS (Chip Select)
Note: For SI, C/D, SHT, SO, and CS, refer to "I/O Procedure".
• RST
• 9D/17D (1/9Duty/1/17Duty)
Input pin for inputting serially commands and display data in an 8-bit unit.
"H"=1 and "L"=0.
When CS pin is at “H” level, read-in is executed by the leading edge of SHT.
Whether input data is a command or data is determined by selecting a C/D level at the
8th leading edge of SHT.
The input data is a command if C/D="H", and display data if C/D="L".
Input pin for determining whether input data for SI pin is a command or display data.
Read-in is executed by the 8th leading edge of SHT. The input data is a command if C/
D="H", and display data if C/D="L".
Clock input pin for reading-in SI input and C/D input.
Read-in is executed by the clock leading edge. Read-in operation is complete with 8
clocks. Maintain this SHT pin at "H" when there is no command and data input from the
SI pin. Inputting data during BUSY may cause malfunction.
Valid if CS pin is at "H" level.
Serial output pin for reading-out BUSY/NON-BUSY and display data. "H"="1" and
"L"="0". If CS pin is at "H" level and Serial out Enable is set with the command, output
is executed.
Otherwise, this pin becomes high impedance. BUSY/NON-BUSY is output when CS
pin is at "H" level. BUSY if "L" and NON-BUSY if "H". It goes BUSY after the 8th leading
edge of SHT, then goes NON-BUSY automatically after a certain time.
Display data is output synchronously with the leading edge of SHT.
Input instruction SOE/D to set this output to Serial Out Enable or a high impedance state
since the pin status is undefined after the power is applied.
Chip Select input pin.
"Chip Select ON" if CS pin is at "H" level, and "Chip Select OFF" at "L" level. When "L"
level is input, SO pin becomes open and SHT pin becomes equivalent to "H" level inside
of the IC. Moreover, it prevents the input rows of SI, C/D and SHT pins from current
flowing.
Direct input reset input pin.
By inputting "L" level pulse into RST pin, SOE/D, DISP, ABBC1/5, and ABB commands
are set as D0="0". Before turning on the power, be sure to set RST pin at "L" level once.
Setting this pin at "L" level during command execution may cause malfunction.
Duty setting input pin.
1/9duty is set if this pin is at "H" level, and 1/17duty at "L" level. Choice depends on the
type of panel to be used.
If 1/9duty is selected, common outputs C10 to C17 should be set open.
FEDL6665C-02
MSM6665C-xx
8/31