MASW-000834-000SMB MA-COM [M/A-COM Technology Solutions, Inc.], MASW-000834-000SMB Datasheet - Page 4

• Manufacturer Part Number: MASW-000834-000SMB
• Description: Application Note on Sample Board Operation of the MASW-000834-13560T T/R Switch
• Manufacturer: MA-COM [M/A-COM Technology Solutions, Inc.]

MASW-000834-000SMB Sample Board
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information
contained herein without notice. M/A-COM makes no warranty, representation or guarantee
regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any
liability whatsoever arising out of the use or application of any product(s) or information.
4
Application Note on Sample Board Operation of the
MASW-000834-13560T T/R Switch
V
V
V
V
The sample board can accommodate dual polarity supplies as shown in Figures 8 through 10. In this
scheme, bias is applied to the Rx , Tx, and DC2 path. Unlike the single positive polarity bias scheme,
bias to the ANT port is not used. A series resistor on the ANT arm and second resistor on the DC2 path
will limit the current when a negative voltage is applied to the TX or RX Port. M/A-COM Tech
supplies 100 Ohm resistors on these sample boards.
In order to achieve proper isolation in the “OFF” arm, the back bias (Vr) on the diodes should be large
enough to sustain higher power levels. The voltage levels can range from +5V to +25V, as shown in
the Figure. Minimum back bias requirements will change depending on incident peak RF Voltage and
frequency of operation. Please contact M/A-COM Technology Solutions for additional guidance on
required reverse bias voltages for specific application environments.
TX
RX
RX
TX
= Negative voltage in which ANT resistor limits current
= Positive voltage level, greater than 0V in which DC2
= Positive voltage level, greater than 0V in which DC2
= Negative Voltage in which ANT resistor limits current
to I
resistor limits current to I
to I
resistor limits current to I
Figure 8. Transmit On, Receive Off
DC
DC
[ANT to RX Path ON]
[ANT to TX Path ON]
Figure 10. Dual Positive and Negative Voltage Source Bias Truth Table
DC BIAS
DC
DC
Dual Positive and Negative Voltage
[RX Path OFF / DC2 Path On]
[RX Path OFF / DC2 Path On]
V
V
V
DC2 = 0V
I
V
V
V
DC2 = 0V
I
DC
DC
ANT
TX
RX
ANT
RX
TX
Dual Bias
Example
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Scheme
= +/- 50mA
= +/- 50mA
= -5V
= +25V
= +25V
= -5V
Visit www.macom.com for additional data sheets and product information.
Figure 9. Transmit Off, Receive On
= 0V
= 0V
RF Condition
Tx - Antenna
Low Loss
Isolation
M/A-COM Products
RF Condition
Rx - Antenna
Low Loss
Isolation
REV.3