MP1518DG MPS [Monolithic Power Systems], MP1518DG Datasheet - Page 3

• Manufacturer Part Number: MP1518DG
• Description: Fixed Frequency WLED Driver Evaluation Board
• Manufacturer: MPS [Monolithic Power Systems]

PRINTED CIRCUIT BOARD LAYOUT
QUICK START GUIDE
NOTICE: The information in this document is subject to change without notice. Users should warrant and guarantee that third
party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not
assume any legal responsibility for any said applications.
EV1518DG-00A Rev. 1.1
7/25/2006
1. Solder LED1 – LED6 to board.
2. Connect the positive and negative terminals of the power supply (2.5V to 6V) to the VIN and
3. This board is set up for automatic startup. Pull EN low to shut down the MP1518.
4. To use burst mode brightness control, drive EN with a PWM signal.
GND pins, respectively.
Figure 1—Top Silk Layer
TM
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
EV1518DG-00A – FIXED FREQUENCY WLED DRIVER EVALUATION BOARD
Figure 3—Bottom Layer
© 2006 MPS. All Rights Reserved.
www.MonolithicPower.com
Figure 2—Top Layer
3