MAX4734EUBT Maxim Integrated Products, Inc., MAX4734EUBT Datasheet - Page 7

• Manufacturer Part Number: MAX4734EUBT
• Description: Max4734 0.8?, Low-voltage, 4-channel Analog Multiplexer
• Manufacturer: Maxim Integrated Products, Inc.

The MAX4734 is a low 0.8
resistance, low-voltage, 4-channel CMOS analog multi-
plexer that operates from a 1.6V to 3.6V single supply.
CMOS switch construction allows switching analog sig-
nals that range from GND to V+.
When powered from a 2.7V supply, the 0.8 (max) R
allows high continuous currents to be switched in a
variety of applications.
Proper power-supply sequencing is recommended for
all CMOS devices. Do not exceed the absolute maxi-
mum ratings, because stresses beyond the listed rat-
ings can cause permanent damage to the devices.
Always sequence V+ on first, followed by NO_ or COM.
Although it is not required, power-supply bypassing
improves noise margin and prevents switching noise
propagation from the V+ supply to other components.
A 0.1µF capacitor, connected from V+ to GND, is ade-
quate for most applications.
Figure 1. Switching Time
Applications Information
V
EN
Detailed Description
A0
A1
EN
GND
MAX4734
(max) (at V+ = 2.7V) on-
V+
V+
NO2–NO4
COM
NO1
R
L
0.8 , Low-Voltage, 4-Channel
V
NO
_
ON
35pF
V
OUT
The MAX4734 logic inputs can be driven up to 3.6V
regardless of the supply voltage. For example, with a
1.8V supply, A_ and EN may be driven low to GND and
high to 3.6V. Driving A_ and EN rail-to-rail minimizes
power consumption.
Analog signals that range over the entire supply voltage
(V+ to GND) can be passed with very little change in on-
resistance (see the Typical Operating Characteristics).
The switches are bidirectional, so the NO_ and COM_
pins can be used as either inputs or outputs.
High-speed switches require proper layout and design
procedures for optimum performance. Reduce stray
inductance and capacitance by keeping traces short
and wide. Ensure that bypass capacitors are as close
to the device as possible. Use large ground planes
where possible.
Test Circuits/Timing Diagrams
V
Analog Multiplexer
EN
= V
V+
V
OUT
IH
+ 0.5
0
0
t
ON
50%
Analog Signal Levels
90%
90%
Logic Inputs
t
t
t
R
F
OFF
< 5ns
< 5ns
Layout