AT24C08C-PUM Atmel, AT24C08C-PUM Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/0/78/atmel_sml.jpg)
AT24C08C-PUM
Manufacturer Part Number
AT24C08C-PUM
Description
EEPROM 8K (1024x8) 2-WIRE 1.7V
Manufacturer
Atmel
Datasheet
1.AT24C08C-SSHM-T.pdf
(24 pages)
Specifications of AT24C08C-PUM
Rohs
yes
Factory Pack Quantity
50
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
AT24C08C-PUM
Manufacturer:
ATMEL
Quantity:
5 000
Part Number:
AT24C08C-PUM
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
5.
Device Operation
Clock and Data Transitions: The SDA pin is normally pulled high with an external device. Data on the SDA pin may
change only during SCL low time periods (see
a Start or Stop condition as defined below.
Start Condition: A high-to-low transition of SDA with SCL high is a Start condition which must precede any other
command (see
Stop Condition: A low-to-high transition of SDA with SCL high is a Stop condition. After a read sequence, the Stop
command will place the EEPROM in a standby power mode (see
Acknowledge: All addresses and data words are serially transmitted to and from the EEPROM in eight bit words. The
EEPROM sends a zero to acknowledge that it has received each word. This happens during the ninth clock cycle.
Standby Mode: The Atmel AT24C04/08C features a low-power standby mode which is enabled:
2-wire Software Reset: After an interruption in protocol, power loss or system reset, any 2-wire part can be reset by
following these steps:
The device is ready for next communication after above steps have been completed.
Figure 5-1. Software Reset
1.
2.
3.
SDA
SCL
Upon power-up
After the receipt of the Stop bit and the completion of any internal operations
Create a start bit condition
Clock nine cycles
Create another start bit followed by stop bit condition as shown below.
Figure 5-5 on page
Start
Bit
1
9).
Figure 5-4 on page
2
Dummy Clock Cycles
3
Figure 5-5 on page
9). Data changes during SCL high periods will indicate
Atmel AT24C04C/08C [DATASHEET]
8
9).
9
Start
8787C–SEEPR–7/12
Bit
Stop
Bit
7