DS21Q41BT+ Maxim Integrated, DS21Q41BT+ Datasheet - Page 20
![no-image](/images/no-image-200.jpg)
DS21Q41BT+
Manufacturer Part Number
DS21Q41BT+
Description
Network Controller & Processor ICs
Manufacturer
Maxim Integrated
Datasheet
1.DS21Q41BT.pdf
(61 pages)
Specifications of DS21Q41BT+
Product
Framer
Number Of Transceivers
4
Data Rate
2.048 Mbps
Supply Current (max)
30 mA
Maximum Operating Temperature
+ 70 C
Mounting Style
SMD/SMT
Package / Case
TQFP-128
Minimum Operating Temperature
0 C
Operating Supply Voltage
5 V
Supply Voltage - Max
5.5 V
Supply Voltage - Min
4.5 V
Part # Aliases
90-21Q41+BT0
CCR3: COMMON CONTROL REGISTER 3 (Address=30 Hex)
LOOP CODE GENERATION
When either the CCR3.1 or CCR3.2 bits are set to one, the DS21Q41B will replace the normal
transmitted payload with either the Loop Up or Loop Down code respectively. The DS21Q41B will
overwrite the repeating loop code pattern with the framing bits. The SCT will continue to transmit the
loop codes as long as either bit is set. It is an illegal state to have both CCR3.1 and CCR3.2 set to 1 at the
same time.
ESMDM
(MSB)
SYMBOL
ESMDM
RSMS
RLOS
TLD
TLU
ESR
PDE
-
ESR
POSITION
CCR3.7
CCR3.6
CCR3.5
CCR3.4
CCR3.3
CCR3.2
CCR3.1
CCR3.0
RLOS
NAME AND DESCRIPTION
Elastic Store Minimum Delay Mode. See Section 10.3 for
details.
0=elastic stores operate at full two-frame depth
1=elastic stores operate at 32-bit depth
Elastic Store Reset. Setting this bit from a 0 to a 1 will force the
elastic stores to a known depth. Should be toggled after
RSYSCLK and TSYSCLK have been applied and are stable.
Must be cleared and set again for a subsequent reset.
Function of the RLOS/LOTC Output.
0=Receive Loss of Sync (RLOS)
1=Loss of Transmit Clock (LOTC)
RSYNC Multiframe Skip Control. Useful in framing format
conversions from D4 to ESF.
0=RSYNC will output a pulse at every multiframe
1=RSYNC will output a pulse at every other multiframe note:
for this bit to have any affect, the RSYNC must be set to output
multiframe pulses (RCR2.4=1 and RCR2.3=0).
Pulse Density Enforcer Enable.
0=disable transmit pulse density enforcer
1=enable transmit pulse density enforcer
Transmit Loop Down Code (001).
0=transmit data normally
1=replace normal transmitted data with loop down code
Transmit Loop Up Code (00001).
0=transmit data normally
1=replace normal transmitted data with loop up code
Not Assigned. Must be set to 0 when written
RSMS
20 of 61
PDE
TLD
TLU
DS21Q41B
(LSB)
-