25AA512-I/SM Microchip Technology, 25AA512-I/SM Datasheet - Page 17

• Manufacturer Part Number: 25AA512-I/SM
• Description: IC EEPROM 512KBIT 20MHZ 8SOIC
• Manufacturer: Microchip Technology

Specifications of 25AA512-I/SM

• Memory Size: 512K (64K x 8)
• Package / Case: 8-SOIC (5.3mm Width), 8-SOP, 8-SOEIAJ
• Operating Temperature: -40°C ~ 85°C
• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Speed: 20MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Organization: 64 K x 8
• Interface Type: SPI
• Maximum Clock Frequency: 20 MHz
• Access Time: 250 ns
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 1.8 V
• Maximum Operating Current: 7 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 1.8 V, 5.5 V
• Memory Configuration: 64K X 8
• Ic Interface Type: SPI
• Clock Frequency: 20MHz
• Supply Voltage Range: 1.8V To 5.5V
• Memory Case Style: SOIJ
• No. Of Pins: 8
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

2.10
The CHIP ERASE instruction will erase all bits (FFh) in
the array. A Write Enable (WREN) instruction must be
given prior to executing a CHIP ERASE. This is done
by setting CS low and then clocking out the proper
instruction into the 25AA512. After all eight bits of the
instruction are transmitted, the CS must be brought
high to set the write enable latch.
The CHIP ERASE instruction is entered by driving the
CS low, followed by the instruction code (Figure 2-10)
onto the SI line.
FIGURE 2-10:
 2010 Microchip Technology Inc.
CHIP ERASE
CHIP ERASE SEQUENCE
SCK
CS
SO
SI
1
0
1
1
High-Impedance
0
2
0
3
The CS pin must be driven high after the eighth bit of
the instruction code has been given or the CHIP
ERASE instruction will not be executed. Once the CS
pin is driven high the self-timed CHIP ERASE instruc-
tion begins. While the device is executing the CHIP
ERASE instruction the WIP bit in the STATUS register
can be read to determine when the CHIP
instruction is complete.
The CHIP ERASE instruction is ignored if either of the
Block Protect bits (BP0, BP1) are not 0, meaning ¼,
½, or all of the array is protected.
0
4
1
5
1
6
1
7
25AA512
DS22021F-page 17
ERASE