MCIMX6D6AVT10AC Freescale Semiconductor, MCIMX6D6AVT10AC Datasheet - Page 98

• Manufacturer Part Number: MCIMX6D6AVT10AC
• Description: Processors - Application Specialized i.MX6D
• Manufacturer: Freescale Semiconductor
• Type: Multimedia Applicationsr

Specifications of MCIMX6D6AVT10AC

• Rohs: yes
• Core: ARM Cortex A9
• Processor Series: i.MX6
• Data Bus Width: 32 bit
• Operating Supply Voltage: 1.05 V to 1.5 V
• Memory Type: L1/L2 Cache, ROM, SRAM

Electrical Characteristics
A frame starts with a rising edge on IPU2_CSIx_VSYNC (all the timings correspond to straight polarity
of the corresponding signals). Then IPU2_CSIx_HSYNC goes to high and hold for the entire line. Pixel
clock is valid as long as IPU2_CSIx_HSYNC is high. Data is latched at the rising edge of the valid pixel
clocks. IPU2_CSIx_HSYNC goes to low at the end of line. Pixel clocks then become invalid and the CSI
stops receiving data from the stream. For the next line, the IPU2_CSIx_HSYNC timing repeats. For the
next frame, the IPU2_CSIx_VSYNC timing repeats.
4.11.10.2.3 Non-Gated Clock Mode
The timing is the same as the gated-clock mode (described in
Section 4.11.10.2.2, “Gated Clock
Mode,”)
except for the IPU2_CSIx_HSYNC signal, which is not used (see
Figure
66). All incoming pixel clocks
are valid and cause data to be latched into the input FIFO. The IPU2_CSIx_PIX_CLK signal is inactive
(states low) until valid data is going to be transmitted over the bus.
Start of Frame
nth frame
n+1th frame
IPU2_CSIx_VSYNC
IPU2_CSIx_PIX_CLK
invalid
invalid
IPU2_CSIx_DATA_EN[19:0]
1st byte
1st byte
Figure 66. Non-Gated Clock Mode Timing Diagram
The timing described in
Figure 66
is that of a typical sensor. Some other sensors may have a slightly
different timing. The CSI can be programmed to support rising/falling-edge triggered
IPU2_CSIx_VSYNC; active-high/low IPU2_CSIx_HSYNC; and rising/falling-edge triggered
IPU2_CSIx_PIX_CLK.
i.MX 6Dual/6Quad Automotive and Infotainment Applications Processors, Rev. 2
98
Freescale Semiconductor