MAX5167MCCM Maxim Integrated, MAX5167MCCM Datasheet - Page 6

• Manufacturer Part Number: MAX5167MCCM
• Description: Sample & Hold Amplifiers
• Manufacturer: Maxim Integrated
• Series: MAX5167r

Specifications of MAX5167MCCM

• Number Of Channels: 32
• Acquisition Time: 4 us
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Package / Case: TQFP-48
• Minimum Dual Supply Voltage: - 4.75 V, + 9.5 V

The MAX5167 has three logic control inputs and five
address lines. The address lines are inputs to a demul-
tiplexer that selects one of the 32 outputs in a standard
addressing scheme
nected to the addressed sample/hold when directed by
the control logic
The three logic control lines determine the state of the
addressed sample/hold. The normal circuit connection
for this device is to hardwire CONFIG and SELECT to
opposing logic voltages. When SELECT and CONFIG
are in opposite states (one high and the other low), the
five address lines select one of the sample/holds. Use
the S/H line to place the selected channel into sample
or hold mode. The other 31 channels will remain in hold
mode.
If an active-high sampling mode is desired, tie S/H and
CONFIG low. In this case, SELECT controls the
addressed channel with a high state putting that chan-
nel into sample mode.
32-Channel Sample/Hold Amplifier
with Output Clamping Diodes
Figure 1. Functional Diagram
6
SELECT
CONFIG
_______________________________________________________________________________________
S/H
IN
(Table
(Table
Detailed Description
2).
1). The analog input is con-
CS
SW1
Digital Interface
SW2
ADDR0–ADDR4
SW30 SW31
The SELECT and CONFIG pins allow the design of a
virtual 64-channel device using two of the MAX5167s.
See the Applications Information section for more infor-
mation about the 64 output addressing scheme.
The MAX5167 contains 32 buffered sample/hold circuits
with internal hold capacitors. Internal hold capacitors
minimize leakage current, dielectric absorption,
feedthrough, and required board space. The value of
the hold capacitor affects acquisition time and droop
rate. Smaller capacitance allows faster acquisition times
but increases the droop rate. Larger values increase
hold acquisition time. The hold capacitor used in the
MAX5167 provides fast 2.5µs (typ) acquisition time while
maintaining a relatively low 1mV/s (typ) droop rate, mak-
ing the sample/hold ideal for high-speed sampling.
When SELECT and CONFIG are in opposing logic states,
the S/H line controls the mode of operation. Sample mode
is entered when S/H is low. During sample mode, the
selected multiplexer channel connects to IN, allowing the
MAX5167
CH
CL
Sample/Hold
Sample Mode
OUT30
OUT31
OUT1
OUT0