M25P32-VME6TG NUMONYX, M25P32-VME6TG Datasheet - Page 36

• Manufacturer Part Number: M25P32-VME6TG
• Description: IC FLASH 32MBIT 75MHZ 8VDFPN
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M25P32-VME6TG

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 32M (4M x 8)
• Speed: 75MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-VDFPN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: M25P32-VME6TG; M25P32-VME6TGTR

7
36/54
Power-up and Power-down
At Power-up and Power-down, the device must not be selected (that is Chip Select (S) must
follow the voltage applied on V
A safe configuration is provided in
To avoid data corruption and inadvertent write operations during Power-up, a Power On
Reset (POR) circuit is included. The logic inside the device is held reset while V
than the Power On Reset (POR) threshold voltage, V
the device does not respond to any instruction.
Moreover, the device ignores all Write Enable (WREN), Page Program (PP), Sector Erase
(SE), Bulk Erase (BE) and Write Status Register (WRSR) instructions until a time delay of
t
correct operation of the device is not guaranteed if, by this time, V
No Write Status Register, Program or Erase instructions should be sent until the later of:
These values are specified in
If the delay, t
selected for READ instructions even if the t
At Power-up, the device is in the following state:
Normal precautions must be taken for supply rail decoupling, to stabilize the V
device in a system should have the V
package pins. (Generally, this capacitor is of the order of 100 nF).
At Power-down, when V
(POR) threshold value, V
any instruction. (The designer needs to be aware that if a Power-down occurs while a Write,
Program or Erase cycle is in progress, some data corruption can result.)
PUW
V
V
t
t
The device is in the Standby mode (not the Deep Power-down mode).
The Write Enable Latch (WEL) bit is reset.
The Write In Progress (WIP) bit is reset.
PUW
VSL
has elapsed after the moment that V
CC
SS
(min) at Power-up, and then for a further delay of t
at Power-down
after V
after V
VSL
CC
, has elapsed, after V
CC
passed the V
passed the V
CC
WI
, all operations are disabled and the device does not respond to
drops from the operating voltage, to below the Power On Reset
Table
CC
CC
) until V
WI
Section 3: SPI
(min) level
8.
threshold
CC
CC
rail decoupled by a suitable capacitor close to the
has risen above V
CC
CC
PUW
reaches the correct value:
rises above the V
delay is not yet fully elapsed.
modes.
WI
– all operations are disabled, and
CC
VSL
(min), the device can be
WI
CC
threshold. However, the
is still below V
CC
CC
feed. Each
CC
is less
(min).