AT88SC0404CA-MP Atmel, AT88SC0404CA-MP Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/0/78/atmel_sml.jpg)
AT88SC0404CA-MP
Manufacturer Part Number
AT88SC0404CA-MP
Description
IC EEPROM 4KBIT 4MHZ M2P
Manufacturer
Atmel
Series
CryptoMemory®r
Datasheet
1.AT88SC0104CA-SU.pdf
(66 pages)
Specifications of AT88SC0404CA-MP
Format - Memory
EEPROMs - Serial
Memory Type
EEPROM
Memory Size
4K (512 x 8)
Speed
4MHz
Interface
I²C, 2-Wire Serial
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
0°C ~ 70°C
Package / Case
M2 P, Smart Card Module
Operating Temperature (max)
70C
Operating Temperature (min)
0C
Operating Temperature Classification
Commercial
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
4.
4.1.
4.2.
4.3.
4.4.
6
Pin Description
Supply Voltage (V
The V
Clock (SCL/CLK)
In the asynchronous T=0 protocol, the SCL/CLK input is used to provide the device with a carrier frequency f. The
nominal length of one bit emitted on I/O is defined as an "elementary time unit" (etu) and is equal to 372/ f. When the
synchronous protocol is used, the SCL/CLK input is used to clock data in on the positive clock edge and clock data out
on the negative clock edge.
Serial Data (SDA/IO)
The SDA pin is bi-directional for serial data transfer. This pin is open-drain driven and may be wired with any number of
other open drain or open collector devices. An external pull up resistor should be connected between SDA and V
nominal value of 4.7K ohm may be used. The value of this resistor and the system capacitance loading the SDA bus
will determine the rise time of SDA. This rise time will determine the maximum frequency during Read operations. Low
value pull up resistors will allow higher frequency operations while drawing higher average power supply current.
Reset (RST)
Atmel
reset sequence is activated, the device will output the data programmed into the 64-bit answer to reset register. When
RST is low, all internal logic, access rights and write cycles are in reset, except the asynchronous mode activation flag.
A weak internal pull-up on the RST input pad allows the device to be used in synchronous mode without bonding RST.
For synchronous only smart card applications an external pull-up on RST is recommended to ensure synchronous
operation under any system timings or conditions. CryptoMemory does not support a synchronous answer to reset
sequence. The RST input is not available in the plastic package options for CryptoMemory.
Figure 3. Connection Diagram
Note:
Atmel AT88SC0104/0204/0404/0808/CA
Microprocessor
®
CC
CryptoMemory
input is a 2.7V to 3.6V positive voltage supplied by the host.
While Atmel CryptoMemory AT88SCXXXXCA is a Low Voltage Device (2.7V to 3.6V) its I/O Buffers are
designed for Standard High Voltage Applications (2.7V to 5.5V)
®
CC
2.7v - 5.5v
provides an ISO 7816-3 compliant asynchronous Answer-To-Reset (ATR) sequence. When the
)
SDA
SCL
CryptoMemory
2.7v - 3.6v
8664C–CRYPT–01/10
CC
, a