MIKROE-504 mikroElektronika, MIKROE-504 Datasheet - Page 16

• Manufacturer Part Number: MIKROE-504
• Description: Development Boards & Kits - PIC / DSPIC BIGDSPIC6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-504

• Rohs: yes
• Product: Development Kits
• Core: dsPIC
• Interface Type: ICD, IDC10, RS-232, USB
• Operating Supply Voltage: 5 V, 9 V to 32 V
• Data Bus Width: 16 bit
• Description/function: Development Board Only, Touch Screen, Pencil, LCD, Serial Cable, GLCD not included
• Dimensions: 265 mm x 220 mm
• For Use With: dsPIC30F

16
BIGdsPIC6 Development System
11.0.
CAN (Controller Area Network) is a communication standard primarily intended for use in automotive industry. It enables the
microcontroller to communicate to a car device without using a host PC. In addition, such communication is widely used in industrial
automation. The BIGdsPIC6 uses the MCP2551 circuit for CAN communication. This circuit provides an interface between the
microcontroller and some peripheral device. To enable connection between the microcontroller and MCP2551, it is necessary to set
switches 5 and 7 on the DIP switch SW14 to the ON position. Switches 6 and 8 on the DIP switch SW14 may also be used for this
purpose. Which of these switches is to be used depends solely on the arrangement of the microcontroller pins connected to CAN
communication lines. The RX line is connected to the microcontroller via RG0 and RF0 microcontroller pins, whereas the TX line is
connected to the microcontroller via RG1 and RF1 microcontroller pins.
: CAN module connector
: CAN module
: Microcontroller and MCP2551 connection schematic
MikroElektronika