MIKROE-504 mikroElektronika, MIKROE-504 Datasheet - Page 25

• Manufacturer Part Number: MIKROE-504
• Description: Development Boards & Kits - PIC / DSPIC BIGDSPIC6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-504

• Rohs: yes
• Product: Development Kits
• Core: dsPIC
• Interface Type: ICD, IDC10, RS-232, USB
• Operating Supply Voltage: 5 V, 9 V to 32 V
• Data Bus Width: 16 bit
• Description/function: Development Board Only, Touch Screen, Pencil, LCD, Serial Cable, GLCD not included
• Dimensions: 265 mm x 220 mm
• For Use With: dsPIC30F

BIGdsPIC6 Development System
20.0. Input/Output Ports
Along the right side of the development system, there are ten 10-pin connectors connected to the microcontroller’s I/O ports. Pins RB0,
RB1, RB6 and RB7 are used for programming and therefore are not directly connected to the appropriate 10-pin connector, but via
the programmer’s multiplexer. DIP switches SW1-SW10 enable each connector pin to be connected to one pull-up/pull-down resistor.
Whether pins of some port are to be connected to a pull-up or a pull-down resistor depends on the position of jumpers J1-J10.
Jumper for pull-up/pull-
down resistor selection
DIP switch to turn on
pull-up/pull-down resis-
tors for each port pin
resistors
: Port PORTB connection schematic
: I/O ports
PORTA 2x5 male connector
Additional module connected
to PORTC
position
position
MikroElektronika
J9 in pull-down
J9 in pull-up
25