KITPF0100EPEVBE Freescale Semiconductor, KITPF0100EPEVBE Datasheet - Page 34

• Manufacturer Part Number: KITPF0100EPEVBE
• Description: Power Management IC Development Tools MMPF0100 Eval Boar
• Manufacturer: Freescale Semiconductor
• Type: PMIC Solutionsr

Specifications of KITPF0100EPEVBE

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: PF0100
• Input Voltage: 3.1 V to 4.5 V
• Output Voltage: 3.1 V to 4.5 V
• Description/function: Evaluation Board
• Interface Type: USB
• Output Current: 3 A to 5 A
• For Use With: PF0100

Graphical User Interface Description
34
Linear regulators can be programmed using the LINEAR sub-tab. It enables the user to control the output voltage
and the start-up sequence of the regulators as well as to choose between the standby and low power mode.
The Interrupts tab provides user access to the four interrupt registers in PF0100 functional register map. The user
can choose to read the interrupts by pressing on the “Read Interrupt x” button.
Each interrupt is latched so that even if the interrupt source becomes inactive, the interrupt will remain set until
cleared. Each interrupt can be cleared by writing a "1" to the appropriate bit in the Interrupt Status register; this will
also cause the INTB pin to go high.
Each interrupt can be masked by setting the corresponding mask bit to a 1. As a result, when a masked interrupt
bit goes high, the INTB pin will not go low. A masked interrupt can still be read from the Interrupt Status register.
The sense registers contain status and input sense bits so the system processor can poll the current state of
interrupt sources. They are read only, and neither latched nor clearable.
Figure 30. LDO Regulators Tab
KTPF0100UG, Rev. 2.0
Freescale Semiconductor