M25P16-VMF6P NUMONYX, M25P16-VMF6P Datasheet - Page 34

• Manufacturer Part Number: M25P16-VMF6P
• Description: IC FLASH 16MBIT 75MHZ 16SOIC
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M25P16-VMF6P

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 16M (2M x 8)
• Speed: 75MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 16-SOIC
• Clock Frequency: 50MHz
• Access Time: 1.4ms
• Supply Voltage Range: 2.7V To 3.6V
• Memory Case Style: SOIC
• No. Of Pins: 16
• Base Number: 25
• Frequency: 50MHz
• Ic: RoHS Compliant
• Memory Configuration: 2M X 8
• Interface Type: Serial, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-3593; 497-3593

7
34/59
Power-up and power-down
At power-up and power-down, the device must not be selected (that is Chip Select (S) must
follow the voltage applied on V
A safe configuration is provided in
To avoid data corruption and inadvertent write operations during power-up, a Power-On
Reset (POR) circuit is included. The logic inside the device is held reset while V
than the Power-On Reset (POR) threshold voltage, V
the device does not respond to any instruction.
Moreover, the device ignores all Write Enable (WREN), Page Program (PP), Sector Erase
(SE), Bulk Erase (BE) and Write Status Register (WRSR) instructions until a time delay of
t
correct operation of the device is not guaranteed if, by this time, V
No Write Status Register, Program or Erase instructions should be sent until the later
occurance of:
These values are specified in
If the delay, t
selected for READ instructions even if the t
At power-up, the device is in the following state:
Normal precautions must be taken for supply rail decoupling, to stabilize the V
Each device in a system should have the V
the package pins. Generally, this capacitor is of the order of 100 nF.
At power-down, when V
(POR) threshold voltage, V
to any instruction. The designer needs to be aware that if a power-down occurs while a
Write, Program or Erase cycle is in progress, some data corruption can result.
PUW
V
V
t
t
The device is in the Standby mode (not the Deep Power-down mode)
The Write Enable Latch (WEL) bit is reset
The Write In Progress (WIP) bit is reset.
PUW
VSL
has elapsed after the moment that V
CC
SS
(min) at power-up, and then for a further delay of t
at power-down
after V
after V
VSL
CC
, has elapsed, after V
CC
passed the V
passed the V
CC
WI
drops from the operating voltage to below the Power-On Reset
, all operations are disabled and the device does not respond
Table
CC
CC
) until V
WI
Section 3: SPI
(min) level.
8.
threshold
CC
has risen above V
CC
CC
CC
PUW
reaches the correct value:
rises above the V
rail decoupled by a suitable capacitor close to
delay is not yet fully elapsed.
modes.
WI
– all operations are disabled, and
VSL
CC
(min), the device can be
WI
CC
threshold. However, the
is still below V
CC
CC
supply.
CC
is less
(min).