MAX16810ATU+T Maxim Integrated Products, MAX16810ATU+T Datasheet - Page 18

• Manufacturer Part Number: MAX16810ATU+T
• Description: IC LED DRVR WT/RGB BCKLT 38-TQFN
• Manufacturer: Maxim Integrated Products
• Type: Backlight, White LED, RGB (Serial Interface)r

Specifications of MAX16810ATU+T

• Constant Current: Yes
• Topology: *
• Number Of Outputs: 16
• Internal Driver: Yes
• Type - Primary: Backlight
• Type - Secondary: RGB, White LED
• Frequency: 20kHz ~ 1MHz
• Voltage - Supply: 8 V ~ 26.5 V
• Voltage - Output: 36V
• Mounting Type: Surface Mount
• Package / Case: 38-TQFN Exposed Pad
• Operating Temperature: -40°C ~ 125°C
• Current - Output / Channel: 55mA
• Internal Switch(s): No
• Low Level Output Current: 6 mA
• High Level Output Current: 1.8 mA
• Operating Supply Voltage: 3 V to 5.5 V
• Maximum Supply Current: 5 mA
• Maximum Power Dissipation: 2857 mW
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Efficiency: -
• Lead Free Status / Rohs Status: Details

Typically, there are two sources of noise emission in a
switching power supply: high di/dt loops and high dv/dt
surfaces. For example, traces that carry the drain cur-
rent often form high di/dt loops. Similarly, the drain of
the internal MOSFET connected to the LX pin presents
a dv/dt source. Keep all PCB traces carrying switching
currents as short as possible to minimize current loops.
Use ground planes for best results.
Careful PCB layout is critical to achieve low switching
losses and clean, stable operation. Use a multilayer
board whenever possible for better noise immunity and
power dissipation. Follow these guidelines for good
PCB layout:
Integrated High-Voltage LED Driver
with Analog and PWM Dimming Control
18
• Use a large copper plane under the MAX16812
• Isolate the power components and high-current
package. Ensure that all heat-dissipating compo-
nents have adequate cooling. Connect the exposed
pad of the device to the ground plane.
paths from sensitive analog circuitry.
______________________________________________________________________________________
Layout Recommendations
• Keep the high-current paths short, especially at the
• Connect AGND and SGND to a ground plane.
• Keep the power traces and load connections short.
• Ensure that the feedback connection to FB is short
• Route high-speed switching nodes away from the
• To prevent discharge of the compensation capaci-
ground terminals. This practice is essential for stable,
jitter-free operation. Keep switching loops short.
Ensure a low-impedance connection between all
ground points.
This practice is essential for high efficiency. Use
thick copper PCBs to enhance full-load efficiency.
and direct.
sensitive analog areas.
tors, C
the dimming cycle, ensure that the PCB area close
to these components has extremely low leakage.
COMP1
and C
COMP2
, during the off-time of