IR3500MPBF International Rectifier, IR3500MPBF Datasheet - Page 24

• Manufacturer Part Number: IR3500MPBF
• Description: IC XPHASE3 CONTROL 32-MLPQ
• Manufacturer: International Rectifier
• Series: XPhase3™r

Specifications of IR3500MPBF

• Applications: Processor
• Current - Supply: 6.5mA
• Voltage - Supply: 4.75 V ~ 7.5 V
• Operating Temperature: 0°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 32-MLPQ
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

phase IC, the OVP circuit overrides the normal PWM operation and will fully turn-on the low side MOSFET within
approximately 150ns. The low side MOSFET will remain on until ISHARE pin voltage drops below V(VCCL) -
800mV, which signals the end of over voltage condition. An over voltage fault condition is latched in the IR3500 and
can only be cleared by cycling power to the IR3500 VCCL.
In the event of a high side MOSFET short before power up, the OVP flag is activated with as little supply voltage as
possible, as shown in Figure 16. The VOSEN+ pin is compared against a fixed voltage of 1.73V (typical) for OVP
conditions at power-up. The ROSC/OVP pin will be pulled higher than 1.6V with VCCLDRV voltage as low as 1.8V.
An external MOSFET or comparator should be used to disable the silver box, activate a crowbar, or turn off the
supply source. The 1.8V threshold is used to prevent false over-voltage triggering caused by pre-charging of output
capacitors.
Pre-charging of converter output voltage may trigger OVP. If the converter output is pre-charged above 1.73V as
shown in Figure 17, ROSC/OVP pin voltage will be higher than 1.6V when VCCLDRV voltage reaches 1.8V.
ROSC/OVP pin voltage will be VCCLDRV-1V and rise with VCCLDRV voltage until VCCL is above UVLO threshold,
after which ROSC/OVP pin voltage will be VCCL-1V. The converter cannot start unless the over voltage condition
stops and VCCL is cycled. If the converter output is pre-charged 130mV above VDAC but lower than 1.73V, as
shown in Figure 17, the converter will soft start until SS/DEL voltage is above 3.92V (4.0V-0.08V). Then, over
voltage comparator is activated and fault latch is set.
(PHASE IC)
(PHASE IC)
OUTPUT
VOLTAGE
IIN
(ISHARE)
FAULT
LATCH
ERROR
AMPLIFIER
OUTPUT
(EAOUT)
GATEH
GATEL
(VO)
Page 24 of 47
VCCL-800 mV
VDAC
OVP
THRESHOLD
Figure 15 - Over-voltage protection during normal operation
NORMAL OPERATION
130mV
OVP CONDITION
May 18, 2009
IR3500
AFTER
OVP