LTM4618EV#PBF Linear Technology, LTM4618EV#PBF Datasheet - Page 9

• Manufacturer Part Number: LTM4618EV#PBF
• Description: IC DC-DC UMODULE BUCK 6A 84-LGA
• Manufacturer: Linear Technology
• Series: µModuler
• Type: Point of Load (POL) Non-Isolatedr

Specifications of LTM4618EV#PBF

• Output: 0.8 ~ 5 V
• Number Of Outputs: 1
• Power (watts): 30W
• Mounting Type: Surface Mount
• Voltage - Input: 4.5 ~ 26.5 V
• Package / Case: 84-LGA
• 1st Output: 0.8 ~ 5 VDC @ 6A
• Size / Dimension: 0.59" L x 0.35" W x 0.17" H (15mm x 9mm x 4.32mm)
• Power (watts) - Rated: 30W
• Operating Temperature: -40°C ~ 125°C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -

OPERATION
Power Module Description
The LTM4618 is a standalone non-isolated switching mode
DC/DC power supply. It can deliver up to 6A (DC current)
output with few external input and output capacitors. This
module provides precisely regulated output voltages pro-
grammable via external resistors from 0.8VDC to 5.0VDC
over 4.5V to 26.5V input voltages. The typical application
schematic is shown in Figure 21. For ≤6V inputs, connect
V
The LTM4618 has an integrated constant frequency current
mode regulator and built-in power MOSFET devices with
fast switching speed. The typical switching frequency is
750kHz.
With current mode control and internal feedback loop
compensation, the LTM4618 module has suffi cient stabil-
ity margins and good transient performance with a wide
range of output capacitors, even with all ceramic output
capacitors.
IN
, INTV
CC
and EXTV
CC
together.
Current mode control provides cycle-by-cycle fast current
limit and current foldback in a short-circuit condition. Pull-
ing the RUN pin below 1.1V forces the controller into its
shutdown state, by turning off both MOSFETs. The TK/SS
pin can be used for programming the output voltage ramp
and voltage tracking during start-up. See the Applications
Information section.
The LTM4618 is internally compensated to be stable over
all operating conditions. LTpowerCAD™ is provided for
transient and stability analysis. The V
program the output voltage with a single external resistor
to ground. Multiphase operation can be easily employed
with the synchronization control.
High effi ciency at light loads can be accomplished with
selectable Burst Mode or pulse-skipping mode operations
using the MODE/PLLIN pin. Effi ciency graphs are provided
for light load operation in the Typical Performance Char-
acteristics section.
LTM4618
FB
pin is used to
4618fa
9