CY3655-PLG Cypress Semiconductor Corp, CY3655-PLG Datasheet - Page 11

• Manufacturer Part Number: CY3655-PLG
• Description: ADAPTER PROG USB
• Manufacturer: Cypress Semiconductor Corp

Specifications of CY3655-PLG

• Accessory Type: Programming Adapter
• Product: Interface Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ICE-CUBE
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Programming enCoRe II or Wireless enCoRe II on the Modular Programmer
enCoRe II devices and Wireless enCoRe II devices can be programmed on the Modular
Programmer using the ICE-Cube. Follow the programming steps below:
Alternatively, a MiniProg programmer (sold separately) can be used for programming rather
than the ICE-Cube. Follow the programming steps below:
1. Using a USB cable, plug the ICE-Cube into a PC that has the PSoC Programmer
2. Connect the yellow ISSP cable to the ICE-Cube through the RJ45 adapter. Note: Do
3. Place the 5-pin end of the ISSP cable on the 5-pin header (J2) of the Modular
4. Place enCoRe II or Wireless enCoRe II device in the socket on the Modular
5. Make sure the appropriate module supporting your specific enCoRe II or Wireless
6. Launch the PSoC Programmer application.
7. In the programming application, select the Port as the ICE-Cube by choosing
8. First select the appropriate device family then select the device to be programmed.
9. Load the programming file using the “File Load” button.
10. Program.
1. Using a USB cable, plug the MiniProg programmer into a PC that has the PSoC
2. Place the MiniProg programmer on the 5-pin header (J2) of the Modular Programmer
3. Place enCoRe II or Wireless enCoRe II device in the socket on the Modular
application installed. Make sure the ICE-Cube is powered on.
not use a black ISSP cable as it does not properly support enCoRe II or Wireless
enCoRe II.
Programmer Base. It will only go on in one orientation.
Programmer Base. Any PDIP package is supported natively. Surface mount devices
will require a surface-mount to PDIP adapter (sold separately). See the Programming
Support Matrix table in the next section for recommended surface-mount to PDIP
adapters.
enCoRe II device is in the memory-style DIMM slot of the Modular Programmer Base.
See the table below to find which module and which orientation of the module supports
your device. Note that the correct side of the module (A or B) must be connected to the
DIMM connector, and the module must be snapped properly in place.
“USB/xxxxCxxx” where the “x” is specific to the USB device ID of your ICE-Cube. Most
likely, the ICE-Cube will be the only device in the list that is not an LPT port.
Programmer application installed.
Base. It will only attach in one orientation.
Programmer Base. Any PDIP package is supported natively. Surface mount devices
will require a surface-mount to PDIP adapter (sold separately). See the Programming
Support Matrix table in the next section for recommended surface-mount to PDIP
adapters.
Page 11 of 16
CY3655 Hardware User Guide