AD9958/PCBZ Analog Devices Inc, AD9958/PCBZ Datasheet - Page 27

• Manufacturer Part Number: AD9958/PCBZ
• Description: BOARD EVALUATION FOR AD9958
• Manufacturer: Analog Devices Inc
• Series: AgileRF™r

Specifications of AD9958/PCBZ

• Design Resources: Low Jitter Sampling Clock Generator for High Performance ADCs Using AD9958/9858 and AD9515 (CN0109) Phase Coherent FSK Modulator (CN0186)
• Main Purpose: Timing, Direct Digital Synthesis (DDS)
• Embedded: No
• Utilized Ic / Part: AD9958
• Primary Attributes: 10-Bit DAC, 32-Bit Tuning Word Width
• Secondary Attributes: 500MHz, Graphical User Interface, 2-Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

SWEEP AND PHASE ACCUMULATOR CLEARING
FUNCTIONS
The AD9958 allows two different clearing functions. The first
is a continuous zeroing of the sweep logic and phase accumula-
tor (clear and hold). The second is a clear and release or automatic
zeroing function. CFR[4] is the autoclear sweep accumulator bit
and CFR[2] is the autoclear phase accumulator bit. The continuous
clear bits are located in CFR, where CFR[3] clears the sweep
accumulator and CFR[1] clears the phase accumulator.
FTW1
FTW0
FTW1
FTW0
f
f
OUT
OUT
SINGLE-TONE
SINGLE-TONE
MODE
MODE
P2 = 0
P2 = 0
AT POINT A: LOAD RISING RAMP RATE REGISTER, APPLY RDW<31:0>
AT POINT B: LOAD FALLING RAMP RATE REGISTER, APPLY FDW<31:0>
A
A
P2 = 1
Figure 39. Linear Sweep Mode (No-Dwell Disabled)
Figure 38. Linear Sweep Mode (No-Dwell Enabled)
LINEAR SWEEP MODE ENABLE—NO-DWELL BIT SET
LINEAR SWEEP MODE
P2 = 0
P2 = 1
B
Rev. A | Page 27 of 44
A
P2 = 1
Continuous Clear Bits
The continuous clear bits are static control signals that, when
active high, hold the respective accumulator at 0 while the bit is
active. When the bit goes low, the respective accumulator is
allowed to operate.
Clear and Release Bits
The autoclear sweep accumulator bit, when set, clears and
releases the sweep accumulator upon an I/O update or a change
in the profile input pins. The autoclear phase accumulator bit,
when set, clears and releases the phase accumulator upon an
I/O update or a change in the profile pins. The automatic
clearing function is repeated for every subsequent I/O update or
change in profile pins until the clear and release bits are reset
via the serial port.
B
B
P2 = 0
P2 = 0
A
P2 = 1
B
TIME
TIME
AD9958