V2DIP2-48 FTDI, Future Technology Devices International Ltd, V2DIP2-48 Datasheet - Page 9
![MOD MCU-USB HOST CTLR 40-DIP](/photos/28/37/283704/v2dip2-48_sml.jpg)
V2DIP2-48
Manufacturer Part Number
V2DIP2-48
Description
MOD MCU-USB HOST CTLR 40-DIP
Manufacturer
FTDI, Future Technology Devices International Ltd
Series
Vinculum-IIr
Datasheet
1.V2DIP2-48.pdf
(25 pages)
Specifications of V2DIP2-48
Main Purpose
Interface, USB 2.0 Host/Controller
Embedded
Yes, ASIC
Utilized Ic / Part
VNC2-48Q
Primary Attributes
Dual A-Type Connector, UART / Parallel FIFO / SPI Interfaces
Secondary Attributes
LED Status Indicators
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
768-1054
3.3 I/O Configuration Using The Jumper Pin Header
Two three way jumper pin headers are provided to allow for simple configuration of the I/O on data and
control bus pins of the 48 pin QFN Vinculum-II. This is done by a combination of pulling up or pulling
down the 48 pin QFN Vinculum-II IOBUS25 (pin 46) and IOBUS26 (pin 47). The relevant portion of the
V2DIP2-48 module schematic is shown in
NOTE: This is only applicable when using VNC1L compatible firmware e.g. V2DAP2. Other wise the user
can set the pins for their own use.
Table 3.2 - V2DIP2 48 Port Selection Jumper Pins
Pull-Up
Pull-Up
Pull-Down
Pull-Down
Figure 3.3 - V2DIP2 48 On-Board Jumper Pin Configuration.
(VNC2-48Q pin 47)
IOBUS25
IOBUS25
IOBUS26
Copyright © 2010 Future Technology Devices International Limited
`
Figure 3.3
V2DIP2-48 VNC2-48 Development Module Datasheet Version 1.01
Pull-Up
Pull-Down
Pull-Up
Pull-Down
(VNC2-48Q pin 46)
IOBUS26
Document Reference No.: FT_000237
Serial UART
SPI
Parallel FIFO
Serial UART
Clearance No.: FTDI# 152
I/O Mode
8