CDB5460AU Cirrus Logic Inc, CDB5460AU Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/1/141/cirrus_logic_inc_sml.jpg)
CDB5460AU
Manufacturer Part Number
CDB5460AU
Description
EVALUATION BOARD FOR CS5460A
Manufacturer
Cirrus Logic Inc
Specifications of CDB5460AU
Main Purpose
Power Management, Energy/Power Meter
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
CS5460A
Primary Attributes
1-Phase Current & Voltage Monitoring
Secondary Attributes
Graphical User Interface, SPI™ & USB Interfaces
Processor To Be Evaluated
CS5460A, C8051F320
Interface Type
USB
Operating Supply Voltage
5 V
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
The EEPROM must be programmed prior to the auto-boot sequence. When the CDB5460AU Evaluation
Board is sent from the factory, the EEPROM is programmed with the following CS5460A command/data
sequence:
This sequence programs the CS5460A for continuous conversion mode. If voltage and current signals are
applied to the inputs, the CS5460A will issue pulses on the EOUT pin. See the CS5460A data sheet for
more details on auto-boot.
DS487DBU1
1. Set Configuration Register, turn high-pass filters on, set K = 1:
2. Set Pulse_Rate Register to 1000 Hz:
3. Set (Unmask) bit 2 (LSD) in the Mask Register:
4. Start continuous conversion:
5. Write STOP bit in Control register, to terminate auto-boot sequence:
0x40 0x00 0x00 0x61
0x4C 0x00 0x7D 0x00
0x74 0x00 0x00 0x04
0xE8
0x78 0x00 0x01 0x00
CDB5460AU
7