EVAL-ADM1068LQEBZ Analog Devices Inc, EVAL-ADM1068LQEBZ Datasheet - Page 6

• Manufacturer Part Number: EVAL-ADM1068LQEBZ
• Description: BOARD EVALUATION FOR ADM1068LQ
• Manufacturer: Analog Devices Inc

Specifications of EVAL-ADM1068LQEBZ

• Main Purpose: Power Management, Power Supply Supervisor/Tracker/Sequencer
• Embedded: No
• Utilized Ic / Part: ADM1068
• Primary Attributes: 10 Channel Supervisor / Sequencer, 6 Voltage Output DACs
• Secondary Attributes: GUI Programmable via SMBus (via USB)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

EVAL-ADM106x
POWERING THE ADM106X EVALUATION
BOARD
The ADM106x evaluation board can be powered through any
one of three power inputs:-
The Evaluation board can be connected to the host PC by the 3-
pin header (J7) which can be connected to the parallel port of a
PC using the cable provided. In such circumstances external
power will need to be supplied to the board using either a 9V
power supply through J9 or alternatively a 9V bench supply
through J11 ( the 9V and GND leads need to be screwed on
separately). Connection to the host PC can also be realized
using the USB port with the cable provided. A 5V supply is not
required when a high current (500mA) port is used. When a
low current (100mA) port is used an external supply will be
required.
Figure 1. powering and communicating with Eval board through the
USB
1.
2.
3.
A 9V power supply through J9.
A 9V bench supply through J11 (the 9V and GND
leads need to be screwed in separately)
A 5V supply through the USB input provided. Note
that a high current (500mA) port must be used to
power the board. If only a low current (100mA) port
is available, then the USB input can be used for data
transfer between the Evaluation board and the host
PC, but an external 9V supply will also need to be
connected.
Rev. PrB | Page 6 of 38
Figure 2. Communicating with EVAL board through SMBus requires
external power through either J9 or J11 as illustrated.
COMMUNICATING WITH THE ADM106x
EVALUATION BOARD
Communication with the ADM106x and its evaluation board is
facilitated by the Graphical User Interface (GUI) provided by
ADI. The latest revision of this software is available for
download at:-
www.analog.com/sequencers
The software is compatible with the following Operating
Systems- Windows 98, Windows 2000, Windows XP.
Communication between a PC and the Eval board is possible
through one of two interfaces:-
1.
2.
The 3-pin header (J6) can be connected to the parallel
port of a PC using the cable provided.
The USB input can be connected to a USB port on a
PC. This cable can also provide power to the board
(see above)*.
Preliminary Technical Data