WAVEVSN BRD 5.1/NOPB National Semiconductor, WAVEVSN BRD 5.1/NOPB Datasheet - Page 7

• Manufacturer Part Number: WAVEVSN BRD 5.1/NOPB
• Description: BOARD INTERFACE DIGITAL HI SPD
• Manufacturer: National Semiconductor
• Series: WaveVisionr

Specifications of WAVEVSN BRD 5.1/NOPB

• Main Purpose: Interface, Data Capture
• Embedded: Yes, ASIC
• Primary Attributes: ADC & DAC Evaluation
• Secondary Attributes: Graphical User Interface, USB Interface
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Utilized Ic / Part: -
• Other names: WAVEVSN BRD 5.1

1.4 Component Description
The following table describes both the on-board connectors and the main components used in the
WaveVision5 System shown in Figure 1.
Component
J1
J2
J3
J4
J5
J7
J10
J11
U2
J8, J9, U27, U28
JP1, JP2
U1
U3-6
U19
LED1
LED6
LED2-5, LED7
LED8-10
LED11-15
LED16-18
LED19
LED20
SW1
SW2
1.5 WaveVision5 Data Capture Board Test Points
The following table describes the main Test Points available.
Test point
J12-J18 (GND)
(Future Bus)
(POWER)
(JTAG)
(USB)
(Mictor)
(LSA)
(HMZd)
(SoftTouch)
(AUG)
1.4.1.1
Future Bus Connector to DUT.
+12V Power Supply Connection (See Section 3.2).
JTAG Header.
USB cable Connection.
Mictor Connector for connecting test equipment or other boards. (See section 2.6).
Logic Analyzer Connector for lower frequency logic analyzers. (See section 2.6).
SoftTouch Connector for high frequency logic analyzers. (See section 2.6).
Header for augmenting the I/O of J5
HMZd Connector to DUT for highest frequency signals.
Connectors for test purposes only.
Jumpers for test purposes only.
FPGA
DDR SRAM (200MHz)
USB microcontroller
Right angle power LED.
Surface mount power LED.
Status LEDs (See section 2.4).
Right angle version of LED2-7 (not used).
DCM Status LEDs (See section 2.4).
Reserved for possible future use.
Warning light - DUT interface is at 2.5V.
Warning light – Aux. Test Equipment/Board interface is at 2.5V.
Power switch.
Reset switch.
Description
Ground test points.
Description
7