MAX4810EVKIT+ Maxim Integrated Products, MAX4810EVKIT+ Datasheet - Page 2

• Manufacturer Part Number: MAX4810EVKIT+
• Description: KIT EVAL FOR MAX4810
• Manufacturer: Maxim Integrated Products

Specifications of MAX4810EVKIT+

• Main Purpose: Interface, 2:1 Multiplexer
• Utilized Ic / Part: MAX4810
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

MAX4810 Evaluation Kit
Before beginning, the following equipment is needed:
•
•
•
•
•
•
•
•
The MAX4810 EV kit is fully assembled and tested.
Follow the steps below to verify board operation.
Caution: Do not turn on the power supply or the
electronic load until all connections are completed.
1) Verify that the jumpers are in their default positions,
2) Connect the +100V power supply to the EV kit
3) Connect the -100V power supply to the EV kit VNN1
4) Connect the +12V power supply to the EV kit VCC
Figure 1. Data Generator Outputs
2
DATA GENERATOR OUTPUT 1
DATA GENERATOR OUTPUT 2
_______________________________________________________________________________________
MAX4810 EV kit
One +100V, 200mA power supply
One -100V, 200mA power supply
One +12V, 200mA power supply
One +3.3V, 200mA power supply
One data generator
One electronic load
One 4-channel oscilloscope
as described in Table 1.
VPP1 pad and connect the ground of the +100V
power supply to the EV kit left GND pad.
pad and connect the ground of the -100V power
supply to the EV kit left GND pad.
pad and connect the ground of the +12V power
supply to the EV kit top GND pad.
Recommended Equipment
f = 5MHz
Quick Start
Procedure
PRF = 1kHz
5) Connect the +3.3V power supply to the EV kit VDD
6) Set the electronic load in constant resistance mode
7) Connect the oscilloscope channel 1 to capture the
8) Connect the oscilloscope channel 2 to capture the
9) Connect the oscilloscope channel 3 to capture the
10) Set the data generator to generate two outputs.
11) Connect the data generator output 1 to the INP1
12) Turn on the power supplies.
13) Enable the data generator outputs.
14) Verify that the signal on the OUT1 pad is similar to
pad and connect the ground of the +3.3V power
supply to the EV kit top GND pad.
at 100Ω. Connect the electronic load positive termi-
nal to the EV kit OUT1 pad. Connect the electronic
load negative terminal to the EV kit left GND pad.
INP1 signal (on the EV kit J1 connector).
INN1 signal (on the EV kit J2 connector).
OUT1 signal (on the EV kit OUT1 pad).
Each output has three pulses in every pulse repeat-
ing period, as shown in Figure 1. Set the pulse
amplitude to +3.3V. Disable the outputs.
logic input (on the EV kit J1 connector). Connect
the data generator output 2 to the INN1 logic input
(on the EV kit J2 connector). Connect the ground of
the data generator to the EV kit top GND pad.
the waveform shown in Figure 2.