IRDCIP1001-A International Rectifier, IRDCIP1001-A Datasheet - Page 12

• Manufacturer Part Number: IRDCIP1001-A
• Description: CONV SGL PHA SYNC BUCK 3.3-4.5V
• Manufacturer: International Rectifier
• Series: iPOWIR™r

Specifications of IRDCIP1001-A

• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Voltage - Output: 2V
• Current - Output: 20A
• Voltage - Input: 3.3 ~ 4.5V
• Regulator Topology: Buck
• Frequency - Switching: 200kHz
• Board Type: Fully Populated
• Utilized Ic / Part: iP1001
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Not Compliant
• Other names: *IRDCIP1001-A

iP1001
Application Issues
Setting V
above 2V
OUT
In certain applications where the output voltage is
required to be set higher than the maximum DAC
code setting of 2V, it is possible to use an external
resistive voltage divider which, for accuracy, needs
to have 1% or better tolerance. The switching
frequency should be set at 200kHz by connecting
the FREQ pin to V
. Also, the output voltage should
DD
never be set higher than 3.3V with a V
minimum of
IN
5V, or 2.5V with a V
minimum of 3.3V. The DAC
IN
code should be set to 2V and the following equation
used to select the resistors:
V
= V
(1 + R3/R4)
x
OUT
F
See the reference design for reference designators.
Note that the impedance at V
is 180K
±35%. It is
F
recommended that R3 be calculated assuming a
value of 1k for R4. Connect V
to V
and GNDS to
FS
F
PGND.
Duty Cycle D = V
/ V
>50%
OUT
IN
For duty cycles >50% the switching frequency should
be set at 200kHz. 300kHz switching frequency can
be selected if the output is less than 2V and the duty
cycle is <50%.
For duty cycles >50%, add external compensation
ramp from the Vsw terminal of the iP1001 device as
shown in the reference design through R9 resistor
and C21 capacitor (Fig 10a.). For optimum perfor-
mance maintain a RC time constant of approximately
5 s.
12
www.irf.com