POEPHYTEREV-I National Semiconductor, POEPHYTEREV-I Datasheet - Page 42

• Manufacturer Part Number: POEPHYTEREV-I
• Description: BOARD EVAL LM5072, DP83848I
• Manufacturer: National Semiconductor
• Series: PHYTER®r

Specifications of POEPHYTEREV-I

• Main Purpose: Special Purpose DC/DC, Power Over Ethernet
• Outputs And Type: 1, Isolated
• Power - Output: 24W
• Voltage - Output: 3.3V
• Current - Output: 7.3A
• Voltage - Input: 39 ~ 57V
• Regulator Topology: Flyback
• Frequency - Switching: 250kHz
• Board Type: Fully Populated
• Utilized Ic / Part: DP83848, LM5072
• Lead Free Status / RoHS Status: Not applicable / Not applicable

www.national.com
7.1.1 Basic Mode Control Register (BMCR)
Bit
15
14
13
12
11
10
9
8
Auto-Negotiation
Speed Selection
Restart Auto-
Duplex Mode
Power Down
Negotiation
Bit Name
Loopback
Enable
Isolate
Reset
Table 12. Basic Mode Control Register (BMCR), address 0x00
Strap, RW
Strap, RW
Strap, RW
0, RW/SC
0, RW/SC
Default
0, RW
0, RW
0, RW
Reset:
1 = Initiate software Reset / Reset in Process.
0 = Normal operation.
This bit, which is self-clearing, returns a value of one until the reset
process is complete. The configuration is re-strapped.
Loopback:
1 = Loopback enabled.
0 = Normal operation.
The loopback function enables MII transmit data to be routed to the MII
receive data path.
Setting this bit may cause the descrambler to lose synchronization and
produce a 500 s “dead time” before any valid data will appear at the
MII receive outputs.
Speed Select:
When auto-negotiation is disabled writing to this bit allows the port
speed to be selected.
1 = 100 Mb/s.
0 = 10 Mb/s.
Auto-Negotiation Enable:
Strap controls initial value at reset.
1 = Auto-Negotiation Enabled - bits 8 and 13 of this register are ig-
nored when this bit is set.
0 = Auto-Negotiation Disabled - bits 8 and 13 determine the port speed
and duplex mode.
Power Down:
1 = Power down.
0 = Normal operation.
Setting this bit powers down the PHY. Only the register block is en-
abled during a power down condition. This bit is OR’d with the input
from the PWR_DOWN/INT pin. When the active low
PWR_DOWN/INT pin is asserted, this bit will be set.
Isolate:
1 = Isolates the Port from the MII with the exception of the serial man-
agement.
0 = Normal operation.
Restart Auto-Negotiation:
1 = Restart Auto-Negotiation. Re-initiates the Auto-Negotiation pro-
cess. If Auto-Negotiation is disabled (bit 12 = 0), this bit is ignored. This
bit is self-clearing and will return a value of 1 until Auto-Negotiation is
initiated, whereupon it will self-clear. Operation of the Auto-Negotiation
process is not affected by the management entity clearing this bit.
0 = Normal operation.
Duplex Mode:
When auto-negotiation is disabled writing to this bit allows the port Du-
plex capability to be selected.
1 = Full Duplex operation.
0 = Half Duplex operation.
42
Description