AD9717-EBZ Analog Devices Inc, AD9717-EBZ Datasheet - Page 47
![BOARD EVAL FOR AD9717](/photos/9/16/91604/ad9717-ebz_sml.jpg)
AD9717-EBZ
Manufacturer Part Number
AD9717-EBZ
Description
BOARD EVAL FOR AD9717
Manufacturer
Analog Devices Inc
Series
TxDAC®r
Datasheet
1.AD9717BCPZ.pdf
(80 pages)
Specifications of AD9717-EBZ
Number Of Dac's
2
Number Of Bits
14
Outputs And Type
2, Differential
Sampling Rate (per Second)
125M
Data Interface
Serial
Dac Type
Current
Voltage Supply Source
Analog and Digital
Operating Temperature
-40°C ~ 85°C
Utilized Ic / Part
AD9717
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
USING THE INTERNAL TERMINATION RESISTORS
The AD9717/AD9716/AD9715/AD9714 have four 500 Ω
termination internal resistors (two for each DAC output).
To use these resistors to convert the DAC output current to a
voltage, connect each DAC output pin to the adjacent load pin.
For example, on the I DAC, IOUTP must be shorted to RLIP
and IOUTN must be shorted to RLIN. In addition, the CMLI
or CMLQ pin must be connected to ground directly or through
a resistor. If the output current is at the nominal 2 mA and the
CMLI or CMLQ pin is tied directly to ground, this produces a
dc common-mode bias voltage on the DAC output equal to 0.5 V.
If the DAC dc bias must be higher than 0.5 V, an external
resistor can be connected between the CMLI or CMLQ pin and
ground. This part also has an internal common-mode resistor
that can be enabled. This is explained in the Using the Internal
Common-Mode Resistor section.
Using the Internal Common-Mode Resistor
These devices contain an adjustable internal common-mode
resistor that can be used to increase the dc bias of the DAC
outputs. By default, the common-mode resistor is not con-
nected. When enabled, it can be adjusted from ~250 Ω to
~1 kΩ. Each main DAC has an independent adjustment
using the lower six bits in Register 0x05 (IRCML[5:0]) and
Register 0x08 (QRCML[5:0]).
Figure 101. Simplified Internal Load Options
Q DAC
I DAC
OR
R
CML
CML
500Ω
500Ω
RLIN
IOUTN
IOUTP
RLIP
Rev. A | Page 47 of 80
Using the CMLx Pins for Optimal Performance
The CMLx pins also serve to change the DAC bias voltages
in the parts allowing them to run at higher dc output bias
voltages. When running the bias voltage below 0.9 V and an
AVDD of 3.3 V, the parts perform optimally when the CMLx
pins are tied to ground. When the dc bias increases above 0.9 V,
set the CMLx pins at 0.5 V for optimal performance. The maxi-
mum dc bias on the DAC output should be kept at or below 1.2 V
when the supply is 3.3 V. When the supply is 1.8 V, keep the dc
bias close to 0 V and connect the CMLx pins directly to ground.
1200
1100
1000
900
800
700
600
500
400
300
200
Figure 102. Typical CML Resistor Value vs. Register Code
0
AD9714/AD9715/AD9716/AD9717
8
16
24
CODE
32
40
48
56