MCP1650DM-LED1 Microchip Technology, MCP1650DM-LED1 Datasheet - Page 15

• Manufacturer Part Number: MCP1650DM-LED1
• Description: BOARD DEMO FOR MCP165X
• Manufacturer: Microchip Technology

Specifications of MCP1650DM-LED1

• Outputs And Type: 1, Non-Isolated
• Features: Dimmable
• Voltage - Input: 2 ~ 4.5V
• Utilized Ic / Part: MCP1651
• Core Chip: MCP1650
• Topology: Boost
• Output Current: 700mA
• Output Voltage: 3.6V
• No. Of Outputs: 1
• Input Voltage: 2V To 4.5V
• Kit Contents: Board
• Development Tool Type: Hardware - Eval/Demo Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Output: -
• Current - Output / Channel: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

5.0
5.1
The MCP1650/51/52/53 boost controller can be used in
several different configurations and in many different
applications. For applications that require minimum
space, low cost and high efficiency, the MCP1650/51/
52/53 product family is a good choice. It can be used in
boost, buck-boost, Single-Ended Primary Inductive
Converters (SEPIC), as well as in flyback converter
topologies.
FIGURE 5-1:
2004 Microchip Technology Inc.
Input
Voltage
3.3V ±10%
APPLICATION CIRCUITS/
ISSUES
Typical Applications
C
IN
Typical Non-Bootstrap Application Circuit (MCP1650/51/52/53).
10 µF
off
on
SHDN
GND
V
NC
IN
3.3V to 12V 100 mA Boost Converter
8
2
6
5
MCP1650
R
0.05
SENSE
4
3
1
7
CS
EXT
NC
FB
5.1.1
Non-bootstrap applications are typically used when the
output voltage is boosted to a voltage that is higher
than the rated voltage of the MCP1650/51/52/53. For
non-bootstrap applications, the input voltage is
connected to the boost inductor through the optional
current sense resistor and the V
51/52/53. For this type of application, the S-option
devices (UVLO at 2.55V, typical) should be used. The
gated oscillator duty cycle will be dependant on the
value of the voltage on V
will be 56%. If V
In non-bootstrap applications, output voltages of over
100V can be generated. Even though the MCP1650/
51/52/53 device is not connected to the high boost
output voltage, the drain of the external MOSFET and
reverse voltage of the external Schottky diode are
connected. The output voltage capacitor must also be
rated for the output voltage.
Inductor
3.3 µH
Boost
MCP1650/51/52/53
Combination Device
MOSFET/Schottky
NON-BOOTSTRAP BOOST
APPLICATIONS
IN
< 3.8V, the duty cycle will be 80%.
IN
90.9 k
10 k
. If V
IN
IN
> 3.8V, the duty cycle
pin of the MCP1650/
C
10 µF
Ceramic
OUT
V
I
DS21876A-page 15
OUT
OUT
= 0 to 100 mA
= 12V