STEVAL-MKI077V1 STMicroelectronics, STEVAL-MKI077V1 Datasheet - Page 10
![BOARD DEMO LPR4150AL GYROSCOPE](/photos/28/40/284035/steval-mki077v1_sml.jpg)
STEVAL-MKI077V1
Manufacturer Part Number
STEVAL-MKI077V1
Description
BOARD DEMO LPR4150AL GYROSCOPE
Manufacturer
STMicroelectronics
Series
MEMSr
Specifications of STEVAL-MKI077V1
Design Resources
STEVAL-MKI077V1 Schematic
Sensor Type
Gyroscope, 2 Axis
Sensing Range
±1500°/sec
Interface
Analog and Digital
Sensitivity
0.67mV/°/s
Voltage - Supply
5V, USB
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
LPR4150AL
Sensing Axis
Double Axis
Output Type
Analog, Digital
Interface Type
USB
Operating Voltage
5 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
LPR4150AL
Other names
497-10595
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
STEVAL-MKI077V1
Manufacturer:
STMicroelectronics
Quantity:
1
System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701