ATSTK526 Atmel, ATSTK526 Datasheet - Page 22

• Manufacturer Part Number: ATSTK526
• Description: KIT STARTER FOR AT90USB82/162
• Manufacturer: Atmel
• Series: AVR®r
• Type: MCUr

Specifications of ATSTK526

• Contents: Starter Kit Board, Power Supply, Cable and Software
• Processor To Be Evaluated: AT90USB82/162
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Silicon Core Number: AT90USB82, AT90USB162
• Kit Contents: Board Docs
• Rohs Compliant: Yes
• For Use With/related Products: AT90USB162, AT90USB82
• For Use With: ATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

STK526 rev. B Hardware User Guide
Parallel High-Voltage
Programming
The STK526 is compatible with the Parallel Programming mode of the STK500. The
embedded RESET circuitry supports the HighVoltage pulses used during programming.
Once the STK526 is plugged into the STK500 Expand connectors, the following
configuration must be set before powering the boards :
On the STK526 :
On the STK500 :
All the Flash memory, EEPROM, all Fuse and Lock Bit can be programmed individually
or with the sequential automatic programming option.
Figure 2-24 . Connecting STK526 to STK500 for High Voltage Parallel Programming
– set the primary power source (Vcc Src jumper) to STK and REG 5V
– set the 3V3REG jumper to “NOREG”
– mount the jumper STKX1 to enable the STK500 clock signal
– connect the PROG_CTRL header (10 pts) to the PORTD header (10pts)
– connect the PROG_DATA header (10 pts) to the PORTB header (10pts)
– mount the following jumpers : VTARGET, RESET, XTAL1, BSEL2
– mount a jumper on the position 1-2 (= right side) of the OSCSEL header
Using the STK526
7709B–AVR–07/08
2-21