101-1050 Rabbit Semiconductor, 101-1050 Datasheet - Page 17

• Manufacturer Part Number: 101-1050
• Description: KIT DEV RABBITCORE RCM3750
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: MPU Moduler

Specifications of 101-1050

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: RCM3750
• Data Bus Width: 8 bit
• Interface Type: Ethernet
• For Use With/related Products: RCM3750
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 101-1049; 101-1049; 316-1117; Q2479714; Q2828455

2.3 Starting Dynamic C
Once the RCM3750 is connected as described in the preceding pages, start Dynamic C by
double-clicking on the Dynamic C icon or by double-clicking on dcrab_XXXX.exe in
the Dynamic C root directory, where XXXX are version-specific characters. Dynamic C
uses the serial port on your PC that you specified during installation.
If you are using a USB port to connect your computer to the RCM3750 module, choose
Options > Project Options
Communications
2.4 Run a Sample Program
Use the
SAMPLES
dow will open on your PC and will display a small square bouncing around in a box.
2.4.1 Troubleshooting
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
If there are any other problems:
• Check that the RCM3750 is powered correctly — the power LED above the
• Check to make sure you are using the
• Check both ends of the programming cable to ensure that they are firmly plugged into
• Ensure that the RCM3750 module is firmly and correctly installed in its connectors on
• Select a different COM port within Dynamic C. From the
User’s Manual
Communications
button on the Prototyping Board should be lit.
programming cable.
the PC and the programming port on the RCM3750.
the Prototyping Board.
Project Options
then click OK. Press
still reports it is unable to locate the target system, repeat the above steps until you locate
the active COM port.
File
folder. Press function key
menu to open the sample program
Serial Options
tab.
, then select
menu. Choose a lower debug baud rate.
<Ctrl-Y>
and select “Use USB to Serial Converter” under the
dialog in the Dynamic C
Communications
to force Dynamic C to recompile the BIOS. If Dynamic C
F9
to compile and run the program. The
PROG
PONG.C
connector, not the
. Select another COM port from the list,
Options > Project Options >
, which is in the Dynamic C
Options
DIAG
menu, select
connector, on the
STDIO
RESET
win-
11