101-1108 Rabbit Semiconductor, 101-1108 Datasheet - Page 57

• Manufacturer Part Number: 101-1108
• Description: KIT EMBEDDED PLC APPLICATION
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: MPU Moduler

Specifications of 101-1108

• Contents: BL2500, ISaGRAF V3.50, Embedded PLC software kernel, ISaGRAF Programming Cable and Documentation
• Processor To Be Evaluated: Rabbit 3000
• Interface Type: RS-232, Ethernet
• For Use With/related Products: BL2500
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 316-1120

EMBEDDED
2. Enter the desired Modbus Slave Number (Default is 1). Select Use Modbus TCP radio button and fill
3. After pressing OK the following message
6.2
To use the
your Rabbit-based controller. Click on File → Load Flash Image; enter the .bin file’s location in the
dialog box and click OK.
This Utility works only with serial connection and it requires the programming cable for the Rabbit-based
controller (1.27mm programming cable for Rabbit 3000 microprocessor based controllers).
This Utility downloads ONLY
file generated with Dynamic C use the Rabbit Field Utility (RFU) that comes in the Dynamic C installation.
6.2.1 Menu Commands
6.2.1.1 File → Load Flash Image
Allows a
button (…) brings up an Open File dialog box to browse for a file’s location.
6.2.1.2 Setup → Communications
This version of the
The default com port is COM1.
The default baud rate is 115200 bps.
If the host PC is using a different com port, change the default to match the port being used by the PC. If
the BIOS is using a different baud rate, change the default to match the baud rate being used by the
BIOS.
6.2.1.3 Setup → File Locations
The first time
are located in the
installation process.
The Rabbit Field Utility can be run from a different location if the location of coldload.bin and
pilot.bin are specified using Setup → File Locations.
OEM Technology Solutions
the Modbus TCP configuration parameters if you want to use Modbus TCP as communication
protocol. Otherwise select Use RS232 or Use RS485 radio buttons. Once all the configuration
parameters have been entered press OK. The communication protocol and slave number are used to
communicate the Target PLC with the ISaGRAF Workbench and Modbus master.
dialog box is shown. Press OK and your
EMBEDDED
active and ready to be used with the
ISaGRAF Workbench (The DS2 red LED
is turned OFF and the DS1-yellow LED
starts flashing every second).
EMBEDDED
EMBEDDED
Note:
The Modbus Slave Number parameter corresponds to the Target Slave Number on
ISaGRAF Workbench (Default is 1). In order to communicate the ISaGRAF Workbench with
a specific Target PLC, both numbers must be the same. This is also valid for
communication between the Target PLC and a Modbus master using Modbus protocol.
PLC BL2500 User’s Manual
EMBEDDED
EMBEDDED
PLC Firmware Kernel will be
EMBEDDED
PLC UTILITY SOFTWARE REFERENCE
EMBEDDED
PLC Kernel (.bin file) to be chosen as the file to be loaded. Clicking the ellipses
PLC Utility you must have an
PLC Utility runs, it assumes that coldload.bin, pilot.bin and flash.ini
PLC Utility subdirectory. Those files are installed by the
EMBEDDED
PLC Utility only supports Serial Connection.
PLC Firmware Kernels. If you want to download another binary
EMBEDDED
Loading or Upgrading the Firmware Kernel
PLC Firmware Kernel (.bin file) to load to
EMBEDDED
PLC
Page 51