XE8000EV101 Semtech, XE8000EV101 Datasheet - Page 5

• Manufacturer Part Number: XE8000EV101
• Description: EVAL BOARD FOR XE8801AMI027LF
• Manufacturer: Semtech
• Type: MCUr

Specifications of XE8000EV101

• Contents: Fully Assembled Evaluation Board
• For Use With/related Products: XE88LC01AMI027
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.6
2.6.1
The XE88LC01A must be placed with its pin 1 marker aligned with the board pin 1 marker. See picture below:
Figure 1 : Position of the chip in the ZIF socket
2.6.2
To use an external power supply, the user must connect the pins on the header named “EXT POWER” near the
battery carrier with a regulated 1.2 to 5.5 Volts power supply. "+" is the pin nearest to the battery.
The switch must be in the “on” position.
Warning this power source is not protected by a fuse!
source to prevent damage to board/chip.
2.6.3
To power the application with a battery, you may place a button battery of the type cr1620 on the carrier (+ on the
top, diameter 16mm height 2.0mm). Since the carrier is flexible, the height can vary a little bit.
Warning this power source is not protected by a fuse!
2.6.4
To use the XE8000EV101 with the ProStart II as a power supply or a programmer please refer to ProStart II user
guide.
Note : When the ProStart II (XE8000MP) is connected all the other supply sources are bypassed, the default
supply of the ProStart II (XE8000MP) is 3.0 Volts and the programming voltage is 5.0 Volts.
2.6.5
To use an external clock source, the user must disconnect the on board xtal by removing the "quartz" jumper, and
place their own source on the pin XIN on the header.
© Semtech 2006
Installing XE8000EV101 hardware
Placing the chip on the ZIF socket
Using an external power supply
Using a button type battery
Using the ProStart II as power supply and programmer
Using an external clock source
5
The user should limit the current of the power supply
pin 1 markers
Users Guide XE8000EV101
Evaluation Board for the
XE88LC01MI027
www.semtech.com