TOOLSTICKSK Silicon Laboratories Inc, TOOLSTICKSK Datasheet - Page 11

• Manufacturer Part Number: TOOLSTICKSK
• Description: KIT STARTER TOOLSTICK
• Manufacturer: Silicon Laboratories Inc
• Series: ToolStickr
• Type: MCUr

Specifications of TOOLSTICKSK

• Contents: Base Adapter, C8051F330 Daughter Card and USB Cable
• Interface Type: USB
• Operating Supply Voltage: 2.7 V to 3.6 V
• Accessory Type: Starter Kit Adapter
• Convert From: USB
• Convert To: Daughter Board
• Development Tool Type: Hardware - Daughter Card
• Mcu Supported Families: ToolStick C8051F330
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F300
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: C8051F330
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 336-1348

6.7. Single-Stepping Through Firmware
The IDE supports the ability to single-step through firmware one assembly instruction at a time. The IDE reads the
Flash from the device, converts the instructions to assembly and displays them in a disassembly window. The
following steps show how to open the disassembly window and single step through firmware.
1. If there is already not a breakpoint set on line of code that increments the Num_LED_Flashes variable, set the
2. Start the processor using the “Go” button and wait till it stops on the breakpoint.
3. Select View → Debug Windows → Disassembly. The disassembly window will appear on the right-hand side
4. To execute one assembly instruction at a time, click the “Step” button on the toolbar or select the Debug →
The disassembly window has three columns. The left column is the address of the instruction in Flash. The middle
column is the instruction in hex. The right column is the disassembled instruction. The Disassembly debug window
and the capability to single-step through firmware allows a developer to see exactly what instructions are executed
and their output.
breakpoint using the steps described in Section 6.6.
of the IDE, if it is not already open.
Step menu option. The highlighted line in the disassembly window indicates the next instruction to be executed.
The blue line marker in the editor window will stay on the same .C source line until all of the assembly
instructions are completed.
Rev. 0.3
ToolStick-F330DC
11