DC-ME-NET Digi International, DC-ME-NET Datasheet - Page 11

• Manufacturer Part Number: DC-ME-NET
• Description: KIT JUMP START ME FOR NET+OS 7.X
• Manufacturer: Digi International
• Series: JumpStartr
• Type: MCU Moduler

Specifications of DC-ME-NET

• Contents: Module, Development Board, Digi JTAG Link, Cable, Power Supply and Software
• Data Rate: 11 Mbps
• Memory Type: Flash, SDRAM
• Interface Type: RS-232, Ethernet
• Operating Voltage: 12 V
• Operating Current: 850 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 85 C
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• For Use With/related Products: Digi Connect ME Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1086

11
Connectors: Ethernet Interface
      
Note:
Note:
Note:
The Ethernet connector is an 8-wire RJ-45 jack that meets the ISO 8877 requirements for
10/100BASE-T. See the following figure and table for pin orientation and pin assignments.
Note:
Ethernet Interface Pin Orientation
17, 18
Pin
19
20
The development board provides connectors for an optional PoE application kit.
Any pins not used can be left floating.
See "Module Pinout" on page 33 for detailed IO configuration information.
Pin orientation and assignments are the same for modules with or without a JTAG
connector.
/INIT
Power and Device Interface Connector Pin Assignments
ME
Signal
/INIT
Wi-ME
Reserved. Do not connect.
Not accessible with Digi Plug-and-Play
Firmware. If using a development kit, see
"Module Pinout" on page 33 for detailed IO
configuration information.
Software Reset
Description