DC-ME-NET Digi International, DC-ME-NET Datasheet - Page 59

• Manufacturer Part Number: DC-ME-NET
• Description: KIT JUMP START ME FOR NET+OS 7.X
• Manufacturer: Digi International
• Series: JumpStartr
• Type: MCU Moduler

Specifications of DC-ME-NET

• Contents: Module, Development Board, Digi JTAG Link, Cable, Power Supply and Software
• Data Rate: 11 Mbps
• Memory Type: Flash, SDRAM
• Interface Type: RS-232, Ethernet
• Operating Voltage: 12 V
• Operating Current: 850 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 85 C
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• For Use With/related Products: Digi Connect ME Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1086

Antenna configurations
59
      
This device has been designed to operate with the antennas listed below, and having a
maximum gain of [10] dBi. Antennas not included in this list or having a gain greater than
[10] dBi are strictly prohibited for use with this device. The required antenna impedance is
[50] ohms
The following antenna configurations that were tested with the Connect Wi-ME 802.11 b
module.
Digi 29000095, Bobbintron SA-006-1, +2 dBi dipole antenna (NP-SMA)
PCTEL, MLPV2400NGP, 2.4 GHz, 3dBi gain, no ground place, low profile antenna
MAXRAD, MFB24010, 2.4 GHz, 10 dBi Fiberglass OMNI antenna
To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.