CY3280-BK1 Cypress Semiconductor Corp, CY3280-BK1 Datasheet - Page 7

• Manufacturer Part Number: CY3280-BK1
• Description: KIT UNIVERSAL CAPSENSE CTRLR
• Manufacturer: Cypress Semiconductor Corp
• Series: PSoC® CapSenser
• Type: DSPr

Specifications of CY3280-BK1

• Contents: 2 Controller Boards, 2 Modules, USB Board, Mini Programmer, Cables and Software
• Interface Type: USB, I2C, SPI
• Operating Voltage: 2.4 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Silicon Manufacturer: Cypress
• Silicon Core Number: CY3280
• Kit Application Type: Sensing - Touch / Proximity
• Application Sub Type: Capacitive Touch
• Silicon Family Name: PSoC
• Rohs Compliant: Yes
• For Use With/related Products: CY8C20x34 and CY8C21x34
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 428-2033

Power the Board
CY3280-BK1 Universal CapSense Controller Quick Start, Doc. # 001-37959 Rev. **
2.
Use the Board as Factory Programmed
The examples in this Quick Start are for the CY3280-20x34 and CY3280-SLM Linear Slider Module
boards only.
The CY3280-20x34 board is preprogrammed with demonstration firmware. When powered by a
PSoC MiniProg, a CY3240-I2USB Bridge, or an optional external power supply, the LEDs light up
when a finger touches one of the buttons or the slider.
These instructions assume your board has not been reprogrammed from the factory settings. If it
has, and you would like to follow along with this demonstration, follow the instructions in the Reset-
ting the Board to the Original Factory Programming section on page 5, and then start this example
with the Power the Board section below.
2.1 Connect your computer to the CapSense test board ISSP Connector (J3)
2.2 Open PSoC Programmer by going to the Windows Start menu and selecting All Programs
MiniProg and a USB cable. If this is your first time using the MiniProg, you will need to install the
driver using these steps before proceeding:
a. When the Found New Hardware Wizard opens, select the Install the software automati-
b. A warning message may tell you the software you are trying to install has not passed Win-
c. When the installation is complete, click Finish.
Cypress MicroSystems
cally (Recommended) option and click Next.
dows Logo testing. Click Continue Anyway each time it appears.
PSoC Programming
PSoC Programmer.
using the PSoC
7