MC56F8323EVME Freescale Semiconductor, MC56F8323EVME Datasheet - Page 24

• Manufacturer Part Number: MC56F8323EVME
• Description: BOARD EVALUATION MC56F8323
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8323EVME

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC56F8322 and MC56F8323
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F83xx
• Rohs Compliant: Yes
• For Use With/related Products: MC56F8322, MC56F8323
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

24
Signal Name
(GPIOB1)
(GPIOB0)
(GPIOA0)
(GPIOA1)
PWMA0
PWMA1
(RXD1)
(TXD1)
MISO0
SS0
Table 2-2 Signal and Package Information for the 64-Pin LQFP
Pin No.
22
21
3
4
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Output
Output
Output
Output
Output
Output
Output
Output
Input/
Input/
Input/
Input/
Input/
Type
Input
Input
State During
disabled,
pull-up is
disabled,
pull-up is
output is
output is
In reset,
In reset,
enabled
enabled
enabled
enabled
pull-up
pull-up
Reset
56F8323 Technical Data, Rev. 17
Input,
Input,
SPI 0 Master In/Slave Out — This serial data pin is an input to a
master device and an output from a slave device. The MISO line of a
slave device is placed in the high-impedance state if the slave device
is not selected. The slave device places data on the MISO line a
half-cycle before the clock edge the master device uses to latch the
data.
Receive Data — SCI1 receive data input
Port B GPIO — This GPIO pin can be individually programmed as
an input or output pin.
After reset, the default state is MISO0.
SPI 0 Slave Select — SS0 is used in slave mode to indicate to the
SPI module that the current transfer is to be received.
Transmit Data — SCI1 transmit data output
Port B GPIO — This GPIO pin can be individually programmed as
an input or output pin.
After reset, the default state is SS0.
PWMA0 — This is one of six PWMA output pins.
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
In the 56F8323, the default state after reset is PWMA0.
In the 56F8123, the default state is not one of the functions offered
and must be reconfigured.
PWMA1 — This is one of six PWMA output pins.
Port A GPIO — This GPIO pin can be individually programmed as
an input or output pin.
In the 56F8323, the default state after reset is PWMA1.
In the 56F8123, the default state is not one of the functions offered
and must be reconfigured
Signal Description
Freescale Semiconductor
Preliminary