101-1157 Rabbit Semiconductor, 101-1157 Datasheet - Page 24

• Manufacturer Part Number: 101-1157
• Description: KIT DEVELOPMENT USA RCM4100
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 4000r
• Type: MPU Moduler

Specifications of 101-1157

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 4001
• Data Bus Width: 8 bit
• Interface Type: SPI
• For Use With/related Products: RCM4100
• Lead Free Status / RoHS Status: Lead free / RoHS compliant by exemption
• Other names: 316-1123

•
20
IOCONFIG_SWITCHECHO.C
and F, which then transmit and then receive an ASCII string when switch S2 or S3 is
pressed. The echoed serial data are displayed in the Dynamic C
Note that the I/O lines that carry the Serial Port E and F signals are not the Rabbit 4000
defaults. The Serial Port E and F I/O lines are configured by calling the library function
serEFconfig()
Serial Port E is configured to use Parallel Port E bits PE6 and PE7. These signals are
available on the Prototyping Board's Module Extension Header (header J2).
Serial Port F is configured to use Parallel Port C bits PC2 and PC3. These signals are
available on the Prototyping Board's RS-232 connector (header J4).
Serial Port D is left in its default configuration, using Parallel Port C bits PC0 and PC1.
These signals are available on the Prototyping Board's RS-232 connector (header J4).
Serial Port D transmits and then receives an ASCII string with Serial Port F when
switch S3 is pressed.
Also note that there are two libraries generated by
SAMPLES\RCM4100\SERIAL
RCM4100 and RCM4120.
To set up the Prototyping Board, you will need to tie TxD
and RxC together on the RS-232 header at J4 using the
jumpers supplied in the Development Kit; you will also
tie TxE (PD6) and RxE (PD7) together with a soldered
wire or with a wire jumper if you have soldered in the
IDC header supplied with the accessory parts in the
Development Kit.
Once you have compiled and run this program, press and
release switches S2 or S3 on the Prototyping Board. The data echoed between the serial
ports will be displayed in the
that was generated by the Rabbit 4000
—This program demonstrates how to set up Serial Ports E
STDIO
folder for the 29 MHz RCM4110 and the 58 MHz
window.
IOCONFIG.EXE
IOCONFIG.EXE
STDIO
in the Dynamic C
RabbitCore RCM4100
window.
utility program.