EPSILON5(SAM7) Equinox Technologies, EPSILON5(SAM7) Datasheet - Page 83

• Manufacturer Part Number: EPSILON5(SAM7)
• Description: ISP PORTABLE HS AT91SAM7 USB
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Portable ISPr

Specifications of EPSILON5(SAM7)

• Contents: Programmer, Software, Cables and Documentation
• For Use With/related Products: ATMEL AT91SAM7 devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1015

4.9 J8 - Atmel 10-way JTAG Header (JTAG Interface)
This connection method is suitable for interfacing the EPSILON5 programmer to a Target System
which features the following:
To implement this connection, simply plug the 10-way ISP cable into the EPSILON5 ISP Header J8
and plug the other end of the cable into the matching header on the Target System.
72
Pin
No
1
2
3
4
5
6
•
•
•
Programmer
Pin name
PROG_TCK
PROG_GND
PROG_TDO
PROG_VCC
PROG_TMS
PROG_RESET
An Atmel device which features a JTAG ISP port e.g. ATmega128 / 323 / 64
Atmel 10-way IDC JTAG Header
This is the same header as used on the Atmel JTAG-ICE emulator.
Programmer
Input /
Output
O
P
I
P
O
O
EPSILON5 MKII Programmer - User Guide V1.12 – 1
Connect to
pin on
Target Device
TCK
GROUND
TDO
TARGET_VCC Target Vcc Connection
TMS
RESET
Figure 4.9.1 - Atmel 10-way IDC Header (J8) viewed from
above
Warning!
Connecting to the wrong ISP Header may cause
catastrophic damage to the Programmer & Target
System
Description
JTAG TCK – Test Clock Signal pin
Clock signal from programmer to Target
Device JTAG port.
Ground Connection
Common ground connection between
Programmer and Target System.
JTAG TDO – Test Data Output pin
Data signal from Target device JTAG port
to programmer.
- Pins 4 + 7 are physically connected
inside the programmer.
- Connects to Vcc rail of Target System.
- Pin referred to as VTref on Atmel JTAG-
ICE.
JTAG TMS – Test Mode Select pin
Mode Select Signal from programmer to
Target Device JTAG port.
Microcontroller RESET control signal
This pin connects to the main RESET pin
of the Target Microcontroller. This pin is
not strictly needed for JTAG programming,
but it can be used to RESET the Target
Device before and after programming.
st
August 2007