M30620T-CPE Renesas Electronics America, M30620T-CPE Datasheet - Page 44

• Manufacturer Part Number: M30620T-CPE
• Description: EMULATOR COMPACT M16C/62A/30/60
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30620T-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/62A, M16C/30, M16C/60
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Table 5.2 Error display and how to remedy it when starting up the emulator (2/2)
(2) Troubleshooting When Emulator Debugger PD30M Starts Up
Table 5.3 lists error messages and how to remedy them when starting up PD30M.
Table 5.3 Error message and how to remedy it when starting up PD30M
Communication ERROR.
Can't accept data.
Not Compact Emulator.
Target MCU is not given clock.
Please reset target systems.
Target MCU is unable to reset.
Please reset target systems.
The version of PD30M and the
firmware on the target are not same.
Please download the firmware
to target.
POWER CLOCK
POWER CLOCK
POWER CLOCK
POWER CLOCK
POWER CLOCK
POWER CLOCK
POWER CLOCK
POWER CLOCK
POWER CLOCK
LED display
Error message
: Blinking
: OFF
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RUN
RUN
RUN
RUN
RUN
RUN
RUN
RUN
RUN
Connection to the
target system
-
Connection to the
( 42 / 52 )
Not connected
Not connected
target system
Connected
Connected
-
-
-
-
Emulator does not work properly.
- The emulator may be damaged. Report LED status to
your local distributor.
- Check the emulator's target status LEDs. If
flashing, the emulator is not working properly.
Check settings as explained in "(1)
Troubleshooting When the Emulator Starts
Up".
- Check the connected serial port and the serial
port settings in the Init dialog box match.
- Try lowering the baud rate in the Init dialog
box.
- Check the connected serial port and the serial
port settings in the Init dialog box match.
- Check an emulator (such as PC4701M,
PC4701HS or PC4701L) is not connected.
- Check the target system's oscillation circuit
works properly when the Clock tab in the Init
dialog box is set to External.
- If the Clock tab in the Init dialog box is set to
External, change it to Internal.
- Check the target system's oscillation circuit
works properly when the Clock tab in the Init
dialog box is set to External.
- If the Clock tab in the Init dialog box is set to
External, change it to Internal.
- Contact your local distributor.
- Contact your local distributor.
Checkpoint
Checkpoint