M30260T2-CPE-GP Renesas Electronics America, M30260T2-CPE-GP Datasheet - Page 79

• Manufacturer Part Number: M30260T2-CPE-GP
• Description: DEV COMPACT EMULATOR M16C/26A,28
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30260T2-CPE-GP

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M16C/26A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30290T2-CPE User’s Manual
REJ10J0494-0200 Rev.2.00 July 16, 2005
Notes on Debugging in CPU Rewrite Mode:
Notes on CE Declaration of Conformity:
When you debug M16C/26A, 28, 29 Group MCUs in CPU rewrite mode, do not change the block 0 area
(FF000h--FFFFFh) of the flash ROM. Otherwise, the emulator will be uncontrollable.
If you check "Debug the program using CPU Rewrite Mode" in the MCU tab of the Init dialog box of the
emulator debugger, you cannot use the following functions.
Do not stop the program in CPU rewrite mode or erase suspend mode. And do not single-step the instructions
shifting to the CPU rewrite mode or erase suspend mode. The emulator will go out of control in CPU rewrite
mode or erase suspend mode.
To reference data after executing CPU rewrite, stop the program at a point which is not a rewrite control
program area and use a memory window etc.
As the following interrupt vectors are used by the emulator system, the read data is different from expected
value.
This product complies with CE marking (EN55022: 1998 Class A, EN55024: 1998 ). Please use it with care
described below.
* This product should be powered down when not in use.
This product generates, uses, and can radiate radio frequency energy and may cause harmful interference to
radio communications.
If this product causes harmful interference to radio or television reception, which can be determined by turning
this product off or on, you are encouraged to try to correct the interference by one or more of the following
methods;
Attach the ferrite core included with this product close to the DC plug of the power cable. Without the ferrite
core it may cause interference.
(1) Setting software breakpoints in an internal ROM area
(2) Executing COME in an internal ROM area
(1) BRK instruction (FFFE4h--FFFE7h)
(2) Address match (FFFE8h--FFFEBh)
(3) Single-step (FFFECh--FFFEFh)
(4) DBC (FFFF4h--FFFF7h)
* Electrostatic Discharge Precautions must be taken when handling the product.
* Must not be used within 30 meters of a domestic radio or television receiver.
* For correct operation of this product, it is recommended that Mobile phones are not used within 10 meters of
* Ensure attached cables do not lie across the probe board and converter board.
* Reorient the receiving antenna.
* Increase the distance between the product and the receiver.
* Connect the product into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or experienced radio/TV technician for help.
The power cable should be wound around the ferrite core as shown in the figure, and close the ferrite core until
it clicks.
this product system.
IMPORTANT
4. Hardware Specifications
Page 77 of 86