HS7058KCI02H Renesas Electronics America, HS7058KCI02H Datasheet - Page 10

• Manufacturer Part Number: HS7058KCI02H
• Description: ON CHIP DEBUG EMULATOR W/TRACE
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In Circuit Debuggerr

Specifications of HS7058KCI02H

• Contents: E10A-LITE, Cable and CD-ROM
• For Use With/related Products: SH7058
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4.1 Recommended Circuit (36-Pin Type)
Figure 4.1 shows a recommended circuit between the H-UDI port connector (36 pins) and the
device.
Notes: 1. Do not connect anything to the N.C. pin of the H-UDI port connector.
6
2. The reset signal in the user system is input to the RES pin of the SH7058RFCC (pin
3. When a joined resistance is used for pull-up, it may be affected by a noise. Separate
4. When the emulator is used, the AUDCK pin must be an end resistance (pulled up or
5. When the emulator is used, connect the CK pin between the H-UDI port connector
6. The pattern between the H-UDI port connector and the device must be as short as
7. The resistance values shown in figure 4.1 are recommended.
8. For the pin processing when the emulator is not used, refer to the hardware manual of
4. Recommended Circuit between the H-UDI Port
58). Connect this signal to the H-UDI port connector as the output from the user
system.
TCK from other resistances.
down by a resistance of several kilo-ohms) because it may be affected by a reflected
noise from the user system interface cable.
and the SH7058RFCC via a buffer (74LVC125 is recommended) as shown in figure
4.1.
possible. Do not connect the signal lines to other components on the board.
the related device.
Connector and the Device