HS7058KCI02H Renesas Electronics America, HS7058KCI02H Datasheet - Page 5

• Manufacturer Part Number: HS7058KCI02H
• Description: ON CHIP DEBUG EMULATOR W/TRACE
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In Circuit Debuggerr

Specifications of HS7058KCI02H

• Contents: E10A-LITE, Cable and CD-ROM
• For Use With/related Products: SH7058
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

To connect the E10A emulator (hereinafter referred to as the emulator), the H-UDI port connector
must be installed on the user system to connect the user system interface cable. When designing
the user system, refer to the recommended circuit between the H-UDI port connector and the
device. In addition, read the E10A emulator user's manual and hardware manual of the related
device.
Table 1.1 shows the type numbers of the emulator, the corresponding connector types, and the use
of AUD function.
Table 1.1 Type Number, AUD Function, and Connector Type
Type Number
HS7058KCM02H, HS7058KCI02H
HS7058KCM01H, HS7058KCI01H
The H-UDI port connector has the 36-pin and 14-pin types as described below. Use them
according to the purpose of the usage.
1. 36-pin type (with AUD function)
2. 14-pin type (without AUD function)
The AUD trace function is supported. A large amount of trace information can be acquired in
realtime. The RAM monitoring function, which accesses (reads or writes) the memory
contents during program execution, is also supported.
The user cannot use the AUD trace function because only the H-UDI function is supported.
For tracing, only the internal trace function is supported. Since the 14-pin type connector is
smaller than the 36-pin type (1/2.5), the area where the connector is installed on the user
system can be reduced.
1. Connecting the Emulator with the User System
Connector
36-pin connector
14-pin connector
AUD Function
Available
Not available
1