R0E0200F2EMU00 Renesas Electronics America, R0E0200F2EMU00 Datasheet - Page 66

• Manufacturer Part Number: R0E0200F2EMU00
• Description: EMULATOR E200F FOR SH7780 SRS
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In-Circuit Emulatorr

Specifications of R0E0200F2EMU00

• Contents: Emulator Board, Cables, Software and Documentation
• For Use With/related Products: SH7780
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6. If a BREAKPOINT cannot be correctly set to an address in the ROM or flash memory area, a
7. If you wish to use a BREAKPOINT (software break), specify the SH2A_SBSTK command to
3.2.5
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Event
2. When an Event Condition is satisfied, emulation may stop after two or more instructions have
3.2.6
The emulator supports the performance measurement function.
1. Setting the performance measurement conditions
Note: For the command line syntax, refer to the online help.
(a) Specifying the measurement start/end conditions
58
mark
window by refreshing the [Memory] window, etc. after Go execution. However, no break will
occur at this address. When the program halts with the break condition, the mark
enable use of a user stack before setting a PC break. While enabled, extra four bytes of a user
stack are used when a break occurs. The value of the stack pointer (R15) must be correctly set
in advance because a user stack is to be used. By default, use of a user stack is disabled. For
details on the command, refer to the help file.
• Example
Condition 3 are disabled.
been executed.
To set the performance measurement conditions, use the [Performance Analysis] dialog box or
the PERFORMANCE_SET command. When any line in the [Performance Analysis] window
is clicked with the right mouse button, a popup menu is displayed and the [Performance
Analysis] dialog box can be displayed by selecting [Setting].
The measurement start/end conditions are specified by using Event Condition 1,2. The
[Ch1,2,3] list box of the [Combination action] dialog box can be used.
To enable use of a user stack:
>SH2A_SBSTK enable
Notes on Setting the [Event Condition] Dialog Box and the BREAKCONDITION_
SET Command
Performance Measurement Function
will be displayed in the [BP] area of the address on the [Source] or [Disassembly]
disappears.