HS2214EPI62H-U Renesas Electronics America, HS2214EPI62H-U Datasheet - Page 211

• Manufacturer Part Number: HS2214EPI62H-U
• Description: DEV EMULATOR BASE UNIT H8S/2214
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS2214EPI62H-U

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8S/2214
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

8.1.7
Selecting [View -> CPU -> Extended Monitor] or clicking the [Extended Monitor] toolbar button displays the
[Extended Monitor] window. This emulator displays the following items.
Table 8.6
Notes: 1. In this emulator, the update interval in the [Extended Monitor] window cannot be selected or changed.
[Item] Column
User Standby
User NMI
User Reset
User Wait
User System Voltage
User Cable
Running status
ROM Write
Target Mode
Target Clock
Target Sub Clock
2. The following item may be displayed instead of [User Standby] depending on the selected MCU.
Extended Monitor Function
User Standby or TESTD: Displays the status of the standby pin and the TESTD pin
[Extended Monitor] Window Items
[Value] Column
Displays the status of the standby pin.
Displays the status of the NMI pin.
Displays the status of the reset pin.
Displays the status of the wait pin ("Inactive" is displayed if no corresponding
pins exist).
Displays whether or not the user VCC equals to or exceeds the value set in
[User VCC Threshold] on the [General] page of the [Configuration Properties]
dialog box.
Displays whether or not the user cable is connected.
Displays the address bus value in the MCU and the status of the CPU while
the user program is running, and the cause of a break while the user program
is halted.
Break = <Cause of break>: Displays the cause of a break.
Address = <Address bus value>:
Displays the address bus value during the user program execution. While in
subactive mode, ‘(SubActive)’ is displayed after the address bus value.
Status = <Status of the CPU>: Displays the status of the CPU.
Displays whether or not the ROM has been written to during the user program
execution.
Once the ROM has been written to, the state is retained until the Configure
Platform is set again.
Displays the mode to be input from the user system.
Displays whether or not there is a clock signal to be input from the user
system.
Displays whether or not there is a sub-clock signal to be input from the user
system. (“Not support” is displayed here when the MCU currently selected
does not support sub-clocks.)
PREFETCH: CPU instruction prefetch cycles
DATA: CPU data access cycles
DMAC: Operation of DMAC
DTC: Operation of DTC
SLEEP: Sleep mode
STANDBY: Standby mode
WATCH: Watch mode
SUBSLEEP: Subsleep mode
REFRESH: Refresh cycles
189